Measurement of radioactivity in aluminum alloys and stainless steel irradiated by 14-MeV D-T neutrons.
نویسندگان
چکیده
منابع مشابه
The Scatteving of 10 and 14 MeV Neutrons
The angular distributions of scattering of 10 and 14Mev neutrons by deuterons have been investigated using photographic emulsions. 1540 deuteron recoils entering the emulsion from a thin target of heavy wax placed in contact with its surface were measured. The results are shown to be in good agreement with the recent theoretical curves of Buckingham, Hubbard and 1VIassey. The errors to which th...
متن کاملMeasurement of local creep properties in stainless steel welds
A high temperature measurement system for creep deformation based on the digital image correlation (DIC) technique is described. The new system is applied to study the behaviour of a multi-pass welded joint in a high temperature tensile test and a load controlled creep test at 545°C. Spatially resolved tensile properties and time dependent creep deformation properties across a thick section typ...
متن کاملAlloy Steel: Properties and Use First-Principles Quantum Mechanical Approach to Stainless Steel Alloys
Accurate description of materials requires the most advanced atomic-scale techniques from both experimental and theoretical areas. In spite of the vast number of available techniques, however, the experimental study of the atomic-scale properties and phenomena even in simple solids is rather difficult. In steels the challenges become more complex due to the interplay between the structural, che...
متن کاملSimultaneous hydroforming of bulge- and T-zone in 304 stainless steel and 70/30 brass tubes
Hydroforming process is largely used for the production of tubular parts in various industries, and has advantages such as less weight, higher quality, more strength and fewer production cost compared to the conventional methods of production. The aim of this study is forming a tube-shaped part with a special geometry that has both bulge- and T-zones with tube hydroforming process. The forming ...
متن کاملAccumulative Roll Bonding of Aluminum/Stainless Steel Sheets
An Al/Stainless Steel/Al lamellar composite was produced by roll bonding of the starting sheets at 400 °C. Afterward, the roll bonded sheet was cut in half and the accumulative roll bonding (ARB) process at room temperature was applied seven times. As a result, the central steel layer fractured and distributed in the Al matrix among different layers introduced by the repetition of roll bonding ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nuclear Science and Technology
سال: 1984
ISSN: 1881-1248,0022-3131
DOI: 10.3327/jnst.21.561