Measurement of Particle Concentration in Powder Coating Process Using Capacitance Computed Tomography
نویسندگان
چکیده
منابع مشابه
Organ Dose Measurement in Computed Tomography Using Thermoluminescence Dosimeter in Locally Developed Phantoms
Introduction: Organ dose estimation using thermoluminescence dosimeter (TLD) is known to be a standard, although many other methods, such as simulation software, optically stimulated luminescent dosimeters, and photodiodes are still in use. This study aimed at directly measuring mean organ doses to the selected organs in the head/neck, chest, and abdominal regions from four computed tomography ...
متن کاملMass Flow Measurement of Biofuels using Electrical Capacitance Tomography
Biomass provides 10% of the global energy supply and electricity generation from biomass and waste is expected to increase by a factor of 4 by 2030. Currently efficiency of biomass power generation is poor and IEA targets improvements from 18% to 25% by 2030 [1]. Such increases in efficiency will require significant new technology and accurate real-time measurement of the flow of these highly v...
متن کاملBone Density Measurement Using Computed Tomography
Osteoporosis is a major medical, social, and economic problem. Osteoporosis and low bone mass affect an estimated 44 million Americans (National Osteoporosis Foundation, 2008). The lifetime risk of hip, spine, or forearm fractures is estimated to be 40% in white women and 13% in white men above 50 years of age. Considerable attention is therefore focused on assessing bone mass and the ability t...
متن کاملImprovement of humidity resistance of magnesium powder using dry particle coating
Dry particle coating is used to enhance the moisture resistance of ground magnesium powder (primary size 75 Am) by coating its surface with carnuba wax (primary size 15 Am). Coating was done using magnetically assisted impact coating (MAIC), and two high-speed impaction-coating devices, the hybridizer and mechanofusion. The uncoated and coated samples are characterized by scanning electron micr...
متن کاملRegulating Concentration Profile in Fluid Flow Using Process Tomography
Process tomography is a sensing technique that can be used to measure distributed flows inside pipes. As a result, it is suitable for use as the sensor in a feedback control system for regulating the concentration of a substance in a fluid flow along the pipe. This paper describes such a control system and starts by developing a model based on the convection-diffusion equation, which describes ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Visualization Society of Japan
سال: 2006
ISSN: 1884-037X,0916-4731
DOI: 10.3154/jvs.26.supplement1_369