Measurement of output force distribution using joint torque
نویسندگان
چکیده
منابع مشابه
Contact Force and Joint Torque Estimation Using Skin
In this paper, we present algorithms to estimate external contact forces and joint torques using only skin, i.e. distributed tactile sensors. To deal with gaps between the tactile sensors (taxels), we use interpolation techniques. The application of these interpolation techniques allows us to estimate contact forces and joint torques without the need for expensive force-torque sensors. Validati...
متن کاملForce-torque Measurement System for Fracture Surgery
Many surgical procedures are now performed using the techniques of minimally invasive surgery (MIS), in which the surgeon manipulates instruments inserted into the patients through small incisions. In MIS, the surgeon has no direct contact with internal body parts. Applying an optimal force and torque via the instruments is necessary to conduct an operation without causing any damage to the int...
متن کاملThe precise control of manipulators with high joint-friction using base force/torque sensing
Joint friction is a major problem in accurate robot position control, particularly during low-speed, small-amplitude tasks. This paper proposes a simple, practical, and e!ective method to compensate for joint friction, using a six-axis force/torque sensor mounted under the manipulator. From these measurements, joint torques are estimated and used in a torque controller, which virtually eliminat...
متن کاملHigh force 10 kN piezoresistive silicon force sensor with output independent of force distribution
A silicon force sensor is realized in which the force is measured by compressing a meander shaped polysilicon strain gage. A second gage which is not loaded, is used for temperature compensation, for compensation of bending and stretching stresses in the chip and for common changes in zero load resistor values. It is shown that the output of the bridge is a linear function of the force and is i...
متن کاملMotion Planning for Redundant Parallel Kinematic Mechanism Using Joint Torque Distribution
This paper presents the motion planning for the redundant parallel kinematic mechanism using joint torque distribution that satisfies a path of the end-effector. The redundant parallel kinematic mechanism more numbers of actuator than numbers of degrees-of-freedom, and it has the advantage of bigger workspace than non-redundant parallel kinematic mechanism by eliminating singularities. The redu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Life Support Engineering
سال: 2007
ISSN: 1341-9455,1884-5827
DOI: 10.5136/lifesupport.19.supplement_146