Measurement of Lengths and Location of Branch Point for Branch Pipes Using Stationary Waves
نویسندگان
چکیده
منابع مشابه
Branch lengths and support.
Although technical definitions exist for various support metrics, the notion of support per se has received little explicit attention. Thus, despite its widespread use in phylogenetics, “support” is absent from the glossaries and/or indices of several recent texts (e.g., Kitching et al., 1998; Page and Holmes, 1998; Schuh, 2001). Farris et al. (2001) recently argued that interpreting branch len...
متن کاملBranch point detection and correction using the branch point potential method
Branch points have been shown to cause problems for adaptive optics (AO) systems which attempt to correct for atmospheric distortion over mid-to-long range horizontal paths. Where branch points (or singularities) occur, the phase of the optical wavefront is undefined and cannot be reconstructed by conventional wavefront reconstruction techniques. Branch points occur in pairs of opposite sign (o...
متن کاملdevelopment of different optical methods for determination of glucose using cadmium telluride quantum dots and silver nanoparticles
a simple, rapid and low-cost scanner spectroscopy method for the glucose determination by utilizing glucose oxidase and cdte/tga quantum dots as chromoionophore has been described. the detection was based on the combination of the glucose enzymatic reaction and the quenching effect of h2o2 on the cdte quantum dots (qds) photoluminescence.in this study glucose was determined by utilizing glucose...
Tree split probabilities determine the branch lengths
The evolution of aligned DNA sequence sites is generally modeled by a Markov process operating along the edges of a phylogenetic tree. It is well known that the probability distribution on the site patterns at the tips of the tree determines the tree and its branch lengths. However, the number of patterns is typically much larger than the number of edges, suggesting considerable redundancy in t...
متن کاملPresenting a New Method Based on Branch Placement for Optimal Placement of Phasor Measurement Units
In this paper, a new method based on branch placement for the optimal positioning of Phasor Measurement Units (PMUs) in power systems is proposed. In this method, the PMUs are in type of single-channel and are installed at the beginning of the branches. Therefore, they are able to measure the bus voltages. Also, the installation of the PMUs on the branches increases the security of observabilit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Institute of Systems, Control and Information Engineers
سال: 2002
ISSN: 1342-5668,2185-811X
DOI: 10.5687/iscie.15.469