Maximum Contact Stresses of WN and Involute Gears.
نویسندگان
چکیده
منابع مشابه
Geometry Definition and Contact Analysis of Spherical Involute Straight Bevel Gears
A practical application of the spherical involute surface to the forged straight bevel gears is provided and demonstrated in this work. Conjugate (pure involute) theoretical surfaces are developed from the input design parameters. The surfaces are modified to suit the actual application (automotive differential). The unloaded (or low load) tooth contact analysis of modified surfaces is performe...
متن کاملgeometry definition and contact analysis of spherical involute straight bevel gears
a practical application of the spherical involute surface to the forged straight bevel gears is provided and demonstrated in this work. conjugate (pure involute) theoretical surfaces are developed from the input design parameters. the surfaces are modified to suit the actual application (automotive differential). the unloaded (or low load) tooth contact analysis of modified surfaces is performe...
متن کاملInfluence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملSpatial involute gearing - a new type of skew gears
This is a geometric approach to spatial involute gearing which has recently been developed by Jack Phillips [4]. Due to Phillips' fundamental theorems helical involute gears for parallel axes (Fig. 2) serve also as tooth flanks for a uniform transmission between skew axes, and the transmission ratio is even independent of the relative position of the axes.
متن کاملOptimal Selection of Addendum Modification Coefficients of Involute Cylindrical Gears
Based on the principles of equalized sliding coefficients and equalized teeth bending strength, the optimization mathematical model for calculating and allocating the addendum modification coefficients of involute cylindrical gear is firstly established. Then the measures to calculate the tooth parameters in real-time during the optimization steps are achieved. Finally, the optimization program...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1996
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.62.729