Mathematical modelling for flexible blade coater with magnetohydrodynamic and slip effects in blade coating process
نویسندگان
چکیده
منابع مشابه
Polymer solar cell by blade coating
Polymer bulk hetero-junction solar cells of poly(3-hexylthiophene) (P3HT) donor and (6,6)-phenyl-C61-butyric acid methyl ester (PCBM) acceptor are fabricated by blade coating in toluene solution. Desired donor–acceptor self-organization is achieved without the slow drying process and high boiling point solvent. Power conversion efficiency is 3.8%, much higher than the 2.6% obtained by spin coat...
متن کاملSimulation of Flexible Mechanisms in a Rotating Blade for Smart-blade Applications
The active Gurney flap technology is investigated to improve the performance of rotorblades by allowing helicopter blades to further control the lift unbalance that rises at high speed and by damping vibration loads on the rotor hub. This technology needs validation by wind tunnel testing of a scaled model blade under rotational loading. An optimised geometry of a flexible actuation system has ...
متن کاملTurbine Blade Tip Leakage Flow Control: Thick/Thin Blade Effects
An experiment was conducted in a linear cascade of Pak-B blades for an exit Mach number of 0.3 to simulate the flow in the tip-gap region of a low pressure turbine blade row. The experiment focused on the independent effects of thickness-to-gap and gapto-chord ratios on the tip-gap flow behavior. Two extreme gap-to-chord ratios of 5% and 8% were chosen, for which four thickness-to-gap ratios we...
متن کاملDynamic Response of Flexible Wind Turbine Blade
Aiming at the non-stationary and stall flutter problems of wind turbine blade caused by transient load fluctuations, the dynamic properties of wind turbine were studied, the blade was simplify to a cantilever beam in case of the action of shear deformation and cross section rotating effect were considered in this analysis, equations of the blade were established based on D'Alemberts' principle ...
متن کاملAll-printed flexible organic transistors enabled by surface tension-guided blade coating.
A combination of surface energy-guided blade coating and inkjet printing is used to fabricate an all-printed high performance, high yield, and low variability organic thin film transistor (OTFT) array on a plastic substrate. Functional inks and printing processes were optimized to yield self-assembled homogenous thin films in every layer of the OTFT stack. Specifically, we investigated the effe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Plastic Film & Sheeting
سال: 2019
ISSN: 8756-0879,1530-8014
DOI: 10.1177/8756087919848807