Mathematical modeling of a three-phase trickle bed reactor
نویسندگان
چکیده
منابع مشابه
Styrene Biofiltration in a Trickle-Bed Reactor
The biological treatment of styrene waste gas in a trickle–bed filter (TBF) was investigated. The bioreactor consisted of a two-part glass cylinder (ID 150 mm) filled with 25 mm polypropylene Pall rings serving as packing material. The bed height was 1m. Although the laboratory temperature was maintained at 22 °C, the water temperature in the trickle–bed filter was slightly lower (about 18 °C)....
متن کاملMathematical modeling of a fixed bed chromatographic reactor for Fischer Tropsch synthesis
In this research, Fischer Tropsch synthesis (FTS) has been modeled in the fixed bed chromatographic reactor for the first time by applying a rather complex dispersed plug flow model for fluid phase and linear driving force (LDF) model for adsorbent. Model equations are dynamic, multi-component, non-linear and heterogeneous including reaction and adsorption simultaneously Complex kinetics fo...
متن کاملImproving Three Phase Modeling of Fluidized Bed Dryer
Heat transfer phenomena in batch fluidized bed dryer have been studied and analyzed using three phase model including solid phase, interstitial gas phase and bubble phase based on Rizzi model. New correlations of heat transfer coefficient to surrounding and convection heat transfer coefficient between solid and interstitial gas are being proposed. In addition, some modifications have been d...
متن کاملTwo Phase Modeling of Char Combustion in a Circulating Fluidized Bed Reactor Using ASPEN PLUS
In this paper, combustion of char in the riser of circulating fluidized bed was modeled using ASPEN PLUS. Since physical and chemical phenomena are involved in the process, the model integrates the two-phase hydrodynamic sub-model with the reaction sub-model derived from the literature. In the proposed model, the fluidized bed is divided into several sections and the behavior of each section wa...
متن کاملI Methanol Synthesis in a Trickle Bed Reactor
INTRODUCTION The conversion of synthesis gas to methanol is practiced commercially in gas phase fixed bed reactors over a Cu/Zn/Al,O1 catalyst. However, because of the highly exothermic nature of the synthesis reactions, heat dissipation has been a bottleneck in the reactor design and process configuration. Moreover, coalderived synthesis gas, having a low H,/CO ratio, is not suitable for use i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Brazilian Journal of Chemical Engineering
سال: 2012
ISSN: 0104-6632
DOI: 10.1590/s0104-66322012000300014