Material removal characteristics of Al-SiO2 composite in WEDM
نویسندگان
چکیده
منابع مشابه
Effects of process parameters on material removal rate in WEDM
Purpose: In this paper, the effects of various process parameters of WEDM like pulse on time (TON), pulse off time (TOFF), gap voltage (SV), peak current (IP), wire feed (WF) and wire tension (WT) have been investigated to reveal their impact on material removal rate of hot die steel (H-11) using one variable at a time approach. The optimal set of process parameters has also been predicted to m...
متن کاملComparison of biological H2S removal characteristics between a composite packing material with and without functional microorganisms
The performances of two identical biofilters, filled with a new composite packing material (named CM-5) embedded with functional microorganisms or sterilized CM-5 without microorganisms, were investigated for H2S treatment. Running parameters in terms of microbial counts, pressure drops, and inlet and outlet H2S concentrations were measured. The results show that the microbial count of the CM-5...
متن کاملExperimental Investigation of Machining Characteristics for the WEDM of Al/ZrO2(p)-PRMMC
Presented is an experimental investigation of the machining characteristics and the effect of wire electrical discharge machine (WEDM) process parameters during machining of Al/ZrO2(p) particulate reinforced metal matrix composite (PRMMC). Experiments are carried out to investigate the effects of input parameters such as dielectric conductivity, pulse width, time between pulses, maximum feed ra...
متن کاملLow-Noise THz SIS Mixers Incorporating NbTiN/SiO2/Al and Al/SiO2/Al Tuning Circuits
The development of the Heterodyne Instrument for the Far-Infrared (HIFI) requires lownoise SIS mixers for frequencies up to 1.25 THz. Past work has shown that the integration of a NbTiN/SiO2/Al tuning circuit with standard Nb SIS junctions enables the development of state-of-the-art heterodyne receivers for frequencies up to at least 1 THz [1-3]. Following from the results of this previous work...
متن کاملOptimization of Material Removal Rate and Surface Roughness for WEDM of Titanium Alloy (Ti-4.5Al-2V) Using Taguchi Method
In this paper, wire electric discharge machining (WEDM) of Titanium alloy (Ti-4.5Al-2V) is studied. In WEDM, the prime objective in cutting operation is to achieve the highest possible cutting speed along with desirable surface finish without sacrificing productivity. It is evident that a high material removal rate and a very good surface finish can never be achieved simultaneously in WEDM. Sel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Epitoanyag - Journal of Silicate Based and Composite Materials
سال: 2020
ISSN: 0013-970X,2064-4477
DOI: 10.14382/epitoanyag-jsbcm.2020.4