Material Modelling and Springback Analysis for Multi-stage Rotary Draw Bending of Thin-walled Tube Using Homogeneous Anisotropic Hardening Model

Analysis of the Rotary-draw Bending Process for Thin-walled Rectangular Aluminum Tube

The Rotary-Draw Bending (RDB) process is a distinguished process employed for the precision cold bending of a hollow tube with small radius bends using Numerical Control (NC) machines. This research presents an analytical model based on the power law hardening model for the RDB processing of rectangular thin tubes. Based on the constraints of the tube in the dies and its thinness, the plane str...

The Effect of Normal Anisotropy on Thin-Walled Tube Bending

Thin-walled tube bending has common applications in the automobile and aerospace industries. The rotary-draw-bending method is a complex physical process with multi-factor interactive effects and is one of the advanced tube forming processes with high efficiency, high forming precision, low consumption and good flexibility for bending angle changes. However, it may cause a wrinkling phenomenon,...

Analysis of Thin-Walled Structures Using Torsional-Bending Elements

In this paper a new element for analysis of thin-walled structures is presented, and the effects of secondary shear stresses on longitudinal displacements are examined. Since the Interpolation Functions are based on non-uniform torsional differential equations, the analysis of stiffness matrix is facilitated. Therefore, its ability to produce accurate results with the least number of elements i...

Analysis of Thin-Walled Structures Using Torsional-Bending Elements

In this paper a new element for analysis of thin-walled structures is presented, and the effects of secondary shear stresses on longitudinal displacements are examined. Since the Interpolation Functions are based on non-uniform torsional differential equations, the analysis of stiffness matrix is facilitated. Therefore, its ability to produce accurate results with the least number of elements i...

Applied on the Rotary Draw Bending Process