Mass transfer, gas hold-up and cell cultivation studies in a bottom agitated draft tube reactor and multiple impeller Rushton turbine configuration

Kinetics of Propane Hydrate Formation in Agitated Reactor: A Mass Transfer Approach

Understanding the kinetics of gas hydrate formation is essential to model and predict the hydrate formation (or dissociation) process. In the present paper, we investigated the formation of pure propane gas hydrate as a former gas. In this regard, several experiments were conducted to measure the rate of hydrate formation under various pressures (410 to 510 kPa) and temperatures (274 K to 277 K...

Investigation of Gas Hold-up and Bubble Behavior in a Split-Cylinder Airlift Reactor: Pseudo-Plastic Non-Newtonian Fluids

Numerical Comparison of Rushton Turbine and CD-6 Impeller in Non-Newtonian Fluid Stirred Tank

A computational fluid dynamics simulation is done for non-Newtonian fluid in a baffled stirred tank. The CMC solution is taken as non-Newtonian shear thinning fluid for simulation. The Reynolds Average Navier Stocks equation with steady state multi reference frame approach is used to simulate flow in the stirred tank. The turbulent flow field is modelled using realizable k-ε turbulence model. T...

investigation of gas hold up and power consumption in a stirred tank bioreactor using single and dual impeller configurations

a laboratory stirred tank bioreactor with six single and dual-impeller configurations was tested to obtain the optimum operating conditions for future biological processes. six impeller combinations consisting of three basic impeller types, namely rushton turbine (rt), pitched 4blade (p4b) and pitched 2blade (p2b) downward flow were investigated in 1.77 l bioreactor working volume. power consum...

Numerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance

Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...