Marginal and Internal Adaptation Evaluation of Dental Composites Using Micro-CT
نویسندگان
چکیده
منابع مشابه
Evaluation of internal adaptation of dental adhesive restorations using micro-CT
Department of Conservative Dentistry, Yonsei University School of Dentistry and Oral Science Research Center, Seoul, Korea Objectives: The internal adaptation of composite restorations with or without resin modified glass ionomer cement (RMGIC) was analyzed non-destructively using Microcomputed tomography (micro-CT). Materials and Methods: Thirty intact human teeth were used. The specimens were...
متن کاملan inverstigation into the shrinkage behavior (kinetics) of microfilled hybrid and nano dental composites
چکیده ندارد.
15 صفحه اولhazard evaluation of gas condensate stabilization and dehydration unit of parsian gas refinery using hazop procedures
شناسایی مخاطرات در واحد 400 پالایشگاه گاز پارسیان. در این پروزه با بکارگیری از تکنیک hazop به شناسا یی مخاطرات ، انحرافات ممکن و در صورت لزوم ارایه راهکارهای مناسب جهت افزایش ایمنی فرا یند پرداخته میگردد. شرایط عملیاتی مخاطره آمیز نظیر فشار و دمای بالا و وجود ترکیبات مختلف سمی و قابل انفجار در واحدهای پالایش گاز، ضرورت توجه به موارد ایمنی در این چنین واحدهایی را مشخص می سازد. مطالعه hazop یک ر...
Micro-CT evaluation of internal adaptation in resin fillings with different dentin adhesives
OBJECTIVES The purpose of present study was to evaluate the internal adaptation of composite restorations using different adhesive systems. MATERIALS AND METHODS Typical class I cavities were prepared in 32 human third molars. The teeth were divided into the following four groups: 3-step etch-and-rinse, 2-step etch-and-rinse, 2-step self-etch and 1-step self-etch system were used. After the d...
متن کاملIn vitro Evaluation of the Marginal Fit and Internal Adaptation of Zirconia and Lithium Disilicate Single Crowns: Micro-CT Comparison Between Different Manufacturing Procedures
RESEARCH ARTICLE In vitro Evaluation of the Marginal Fit and Internal Adaptation of Zirconia and Lithium Disilicate Single Crowns: Micro-CT Comparison Between Different Manufacturing Procedures Francesco Riccitiello, Massimo Amato, Renato Leone, Gianrico Spagnuolo # and Roberto Sorrentino Department of Neurosciences, Reproductive and Odontostomatological Sciences, University “Federico II” of Na...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Materials Science and Engineering
سال: 2019
ISSN: 1687-8434,1687-8442
DOI: 10.1155/2019/5010319