منابع مشابه
Assembly system facility design
This paper addresses the design of an assembly system facility consisting of multiple assembly lines of different shapes. In such a design problem there are two conflicting objectives: (i) to minimize the overall area of the facility; and (ii) to maximize the efficiency of the material handling transportation system. We first address the optimization problem of objective (ii) when replacing obj...
متن کاملAn Open Architecture Inspection System
The benefits of open architectures are not currently available for most manufacturing equipment. We describe a testbed for experimenting with an open architecture controller for an inspection system. An initial taxonomy of categories of openness is proposed, culminating in "plug and play," which does not require a software rebuild. The testbed and its constituent components are described with r...
متن کاملWAAS-Based Flight Inspection System
Maintaining the accuracy of an Instrument Landing System (ILS) is very important because it is the primary landing guidance system during bad weather in the U.S. Therefore, the FAA periodically checks the accuracy of an ILS and calibrates any deviation, a procedure called Flight Inspection (FI). In order to check the accuracy of an ILS, the FAA uses an Inertial-based Automated Flight Inspection...
متن کاملConvergence Analysis of Backpropagation Algorithm for Designing an Intelligent System for Sensing Manhole Gases
Human fatalities are reported due to the excessive proportional presence of hazardous gas components in manhole, such as Hydrogen Sulfide, Ammonia, Methane, Carbon Dioxide, Nitrogen Oxide, Carbon Monoxide, etc. Hence, predetermination of these gases is imperative. A neural network (NN) based intelligent sensory system is proposed for the avoidance of such fatalities. Backpropagation (BP) was ap...
متن کاملDevelopment of Inspection System for Wooden Chopsticks
Our aim is to development of the inspection system of wooden chopsticks, and in this paper, we develop the prototype for high-class disposable wooden chopsticks by computer vision technology. We propose a method of inspecting the four items of fine grain sample, coarse grain sample, unpeeled sample, and defective sample. Moreover, we addressed not only the proposal of the algorithm but developm...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1992
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.58.2519