Maneuvering and Active Vibration Control of Slewing Flexible Beam Using Input Shaper
نویسندگان
چکیده
منابع مشابه
Active Vibration Control of Flexible Beam using Differential Evolution Optimisation
This paper presents the development of an active vibration control using direct adaptive controller to suppress the vibration of a flexible beam system. The controller is realized based on linear parametric form. Differential evolution optimisation algorithm is used to optimize the controller using single objective function by minimizing the mean square error of the observed vibration signal. F...
متن کاملEfficiency of Active Control of Beam Vibration Using PZT Patches
This study is aimed to explore efficiency problems of using PZT patches in active vibration control of beams. The PZT patches are surface-bonded as actuators and strain gages are used as sensors. Distributed moment forcing mode is adopted to derive the control authority of actuators. Uniform beam model is applied when the mass and stiffness of PZT patches are ignored. Stepped beam model is then...
متن کاملRobust Optimal Control of Flexible Spacecraft During Slewing Maneuvers
In this paper, slewing maneuver of a flexible spacecraft with large angle of rotation is considered and assuming structural frequency uncertainties a robust minimum-time optimal control law is developed. Considering typical bang-bang control commands with multiple symmetrical switches, a parameter optimization procedure is introduced to find the control forces/torques. The constrained minimizat...
متن کاملInput Shaper Designs for Minimizing the Expected Levelof Residual Vibration in Flexible StructuresLucy
The method of input shaping has been shown to yield good performance in the control of exible structures while being insensitive to modeling errors. However, previous studies do not take into account the distributions of the parameter variations. We develop a new input shaping method that allows the ranges of system parameter values to be weighted according to the expected modeling errors. Comp...
متن کاملVibration control of an automotive engine using active mounts
In this research, vibration control of national engine (EF7) using active mounts is studied for two different mounting layouts. The first layout is based on the current engine mounting of national engine (system of three passive mounts), but the hydraulic mount is substituted by an active mount. The other mounting layout contains 4 mounts, 2 of which are active ones and the others are passive m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Korean Society for Noise and Vibration Engineering
سال: 2012
ISSN: 1598-2785
DOI: 10.5050/ksnve.2012.22.6.542