Magnetic Properties of Semi-hard Magnetic Alloys in Fe-W-Cr-Mo System by Powder Metallurgy

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Crystallization behavior and magnetic properties of Cu-containing Fe–Cr–Mo–Ga–P–C–B alloys

Multicomponent Fe65.5Cr4Mo4Ga4P12C5B5.5 amorphous alloy is known to have good soft magnetic properties combined with large glass-forming ability. Searching for a nanocrystalline structure that could improve its magnetic properties, Cr and Mo were partially substituted by Cu. The devitrification process of Cu-containing alloys shows an additional broad crystallization event that can be described...

متن کامل

Interdiffusion of Refractory Elements in Fe-Cr-X (X-Mo, W) and Fe-Mo-W Ternary Iron Alloys

Interdiffusion coefficients of the refractory elements in Fe-Cr-X (X 1⁄4 Mo, W) and Fe-Mo-W ternary alloys were measured on the basis of the modified Boltzmann-Matano method for ternary systems. The cross interdiffusion coefficient, ~ D CrW was positive in Fe-Cr-W ternary alloy, indicating that W accelerates interdiffusion between Fe and Cr atoms. On the other hand, the cross interdiffusion coe...

متن کامل

High Magnetic Permeability Alloys Hardperm in the Ni-Fe-Ta-Mo System*

Starting materials used were 99.8% pure nickel, 99.9% pure iron, 99.9% pure tantalum, and 99.9% pure molybdenum. The materials in a total weight of 500g were melted with a high-frequency induction furnace in vacuum. The melt was poured into an iron mold with an opening of 20mm diameter and 150mm length. After forging, the ingot was reduced to a thin plate 0.3mm in thickness by rolling and a wir...

متن کامل

AN INVESTIGATION ON ABRASIVE WEAR BEHAVIOUR OF Fe-C-Mo-FeCr COMPOSITE PRODUCED BY POWDER METALLURGY

In this study, the effect of chromium carbide (Cr7C3) on abrasive wear behavior of Fe-C-Mo-FeCr composite was investigated. Composite, which was produced by a powder metallurgy route was containing 3 wt.% Mo, 1.5 wt. % C and 4,8,12 wt. % FeCr with the different particle sizes. In the experiments, wear resistance of samples were determined using different loads by a pin on disc wear tester. Micr...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy

سال: 1973

ISSN: 0532-8799,1880-9014

DOI: 10.2497/jjspm.19.249