Magnetic Anisotropy in Case-Carburized Surfaces after Hard Turning

Cutting Disturbances in Hard Turning Process

Assumption of cutting disturbances in hard turning process (caused by variations in depth of cutting, high passive force Fp or small tool nose radius) could be confirmed with several indicators. These indicators can be monitored during turning process(forces, vibrations, sound, etc.) or after process has been finished (roughness, temperature, wear, etc). Variation of depth of cutting as well as...

Manufacturing Technology I Exercise 8 Hard Turning – Hard Roller Burnishing

Turning hard problems on their heads

Much of the difficulty in assessing theories of consciousness stems from their advocates not supplying adequate or convincing characterisations of the phenomenon (or data) they hope to explain. Yet, to make any reasonable assessment this is precisely what is required, for it is not as if our ‘pre-theoretical’ intuitions are philosophically innocent. In what follows, I will attempt to reveal, us...

magnetic resonance imaging in dentistry

چکیده ندارد.

Magnetic anisotropy in itinerant magnets