Magnet Software Based Fault Analysis of Induction Motor Using Finite Element Analysis
نویسندگان
چکیده
منابع مشابه
A New Restructured Shaded Pole Induction Motor- 3D Finite Element Analysis and Experimental Verification
Shaded pole induction motors, despite the simplicity and low cost, are difficult to analyze particularly in the equivalent circuit methods, due to the asymmetric structure, saturation, harmonics, inaccurate estimation of leakage inductances and skew. Hence, 3D numerical methods could be very useful in the design and optimization stage. This paper presents the 3D transient finite element analysi...
متن کاملStability Analysis of Salt Cavern Gas Storage Using 2D Thermo-Hydro-Mechanical Finite-Element Software
Ensuring the stability and integrity of underground gas storage salt caverns is a very complicated subject due to the non-linear and time-dependent behavior of rock salts under complicated thermal and mechanical loading conditions. For this reason, pressure and temperature fluctuations in the caverns and their surrounding strata must be integrated into the analysis and the numerical tools that ...
متن کاملElectromagnetic Analysis of a Modular Flux-switching Permanent-magnet Motor Using Finite-element Method
This paper proposes a new 3-phase flux-switching permanent-magnet (FSPM) motor termed as modular FSPM (MFSPM) motor, for high reliability applications. Due to PMs in the stator, the proposed motor offers high efficiency, simple and robust rotor structure, and good thermal dissipation conditions. The key is the new motor topology which incorporates the concept of faulttolerant teeth to provide t...
متن کاملFinite Element Analysis of Permanent Magnet Synchronous Motors Subjected to Symmetrical Voltage Sags
This paper studies the effects of symmetrical voltage sags on the operational characteristics of a Permanent Magnet Synchronous Motor (PMSM) by Finite Element Method (FEM). Voltage sags may cause high torque pulsations which can damage the shaft or equipment connected to the motor. By recognizing the critical voltage sags, sags that produce hazardous torque variations could be prevented. Simula...
متن کاملAnalysis of Roll Wear in Reshaping Using Finite Element Simulation
Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOSR Journal of Electrical and Electronics Engineering
سال: 2013
ISSN: 2320-3331,2278-1676
DOI: 10.9790/1676-0510108