Machining Performance for Machinable Ceramics. (Part 7). Finish Cutting.
نویسندگان
چکیده
منابع مشابه
On-Line Estimation of Groove Wear in the Minor Cutting Edge for Finish Machining
The paper investigates the effective detection and esdmation of = m v e wear at the minor cutting edge, which has a mtal influence on surface quality in finish-machining. During bar-turning experiments with different cutting conditions, a miniature 3-D accelerometer, mounted in close vicinity to the tool tip, was used to measure the multivariate vibration signal produced by the turning process....
متن کاملOn the Modeling and Analysis of Machining Performance in Micro-Endmilling, Part II: Cutting Force Prediction
In Part II of this paper, a cutting force model for the micro-endmilling process is developed. This model incorporates the minimum chip thickness concept in order to predict the effects of the cutter edge radius on the cutting forces. A new chip thickness computation algorithm is developed to include the minimum chip thickness effect. A slip-line plasticity force model is used to predict the fo...
متن کاملInfluence of Electrical Resistivity and Machining Parameters on Electrical Discharge Machining Performance of Engineering Ceramics
Engineering ceramics have been widely used in modern industry for their excellent physical and mechanical properties, and they are difficult to machine owing to their high hardness and brittleness. Electrical discharge machining (EDM) is the appropriate process for machining engineering ceramics provided they are electrically conducting. However, the electrical resistivity of the popular engine...
متن کاملNumerical simulations and cutting experiments on single point diamond machining of semiconductors and ceramics
This chapter presents numerical simulation work and single-point nano-machining experiments conducted on semiconductor and ceramic materials, e.g. silicon (Si) and silicon carbide (SiC). The apparent ductile mode material removal mechanism observed in these materials is believed to be the result of a high pressure phase transformation (HPPT), which generates a small Correspondence/Reprint reque...
متن کاملMachining with Minimal Cutting Fluid
The purpose of cutting fluid in a machining operation is to cool the workpiece, reduce friction, and wash away the chips. The cutting fluid contributes significantly toward machining cost and also possesses environmental threats. In the past, there have been some attempts to minimize the amount of cutting fluid in machining. This chapter reviews some prominent ways to minimize the application o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1992
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.39.646