Machining performance for machinable ceramics. (Part 4). Wet cutting.
نویسندگان
چکیده
منابع مشابه
On the Modeling and Analysis of Machining Performance in Micro-Endmilling, Part II: Cutting Force Prediction
In Part II of this paper, a cutting force model for the micro-endmilling process is developed. This model incorporates the minimum chip thickness concept in order to predict the effects of the cutter edge radius on the cutting forces. A new chip thickness computation algorithm is developed to include the minimum chip thickness effect. A slip-line plasticity force model is used to predict the fo...
متن کاملInfluence of Electrical Resistivity and Machining Parameters on Electrical Discharge Machining Performance of Engineering Ceramics
Engineering ceramics have been widely used in modern industry for their excellent physical and mechanical properties, and they are difficult to machine owing to their high hardness and brittleness. Electrical discharge machining (EDM) is the appropriate process for machining engineering ceramics provided they are electrically conducting. However, the electrical resistivity of the popular engine...
متن کاملNumerical simulations and cutting experiments on single point diamond machining of semiconductors and ceramics
This chapter presents numerical simulation work and single-point nano-machining experiments conducted on semiconductor and ceramic materials, e.g. silicon (Si) and silicon carbide (SiC). The apparent ductile mode material removal mechanism observed in these materials is believed to be the result of a high pressure phase transformation (HPPT), which generates a small Correspondence/Reprint reque...
متن کاملMachining with Minimal Cutting Fluid
The purpose of cutting fluid in a machining operation is to cool the workpiece, reduce friction, and wash away the chips. The cutting fluid contributes significantly toward machining cost and also possesses environmental threats. In the past, there have been some attempts to minimize the amount of cutting fluid in machining. This chapter reviews some prominent ways to minimize the application o...
متن کاملAbrasive machining of advanced technical ceramics
The high cost of ceramic components can be associated with complex and time-consuming postmachining, which is currently done by using abrasive machining processes. The IWF and Fraunhofer-IPK are undertaking research activities in the field of abrasive machining which aim at developing and optimizing technologies to expand the application field and to increase productivity of high-performance ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1990
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.37.857