Machinalibilty of Ti-6Al-4V Under Dry and Near Dry Condition Using Carbide Tools
نویسندگان
چکیده
منابع مشابه
Fatigue of Ti-6Al-4V
Metallic biomaterials have essentially three fields of use; these are the artificial hip joints, screw, plates and nails for internal fixation of fractures, and dental implants. Any of these devices must support high mechanical load and resistance of material against breakage is essential. High mechanical properties are needed for structural efficiency of surgical and dental implants. But their...
متن کاملPrecision Grinding of Titanium (Ti-6Al-4V) Alloy Using Nanolubrication
In this current era of competitive machinery productions, the industries are designed to place more emphasis on the product quality and reduction of cost whilst abiding by the pollution-preventing policy. In attempting to delve into the concerns, the industries are aware that the effectiveness of existing lubrication systems must be improved to achieve power-efficient and pollutionpreventing ma...
متن کاملThe vacuum hot pressing behavior of silicon carbide fibers coated with nanocrystalline Ti–6Al–4V
The vacuum hot pressing (VHP) of silicon carbide monofilaments coated with nanocrystalline Ti–6Al–4V has been studied. During consolidation, very high densification rates were observed, even at temperatures and pressures well below those normally used for processing conventional Ti–6Al–4V. From the cross-sections of partially consolidated specimens, the evolution of coated fiber–fiber contacts ...
متن کاملGas nitriding and subsequent oxidation of Ti-6Al-4V alloys
Ti-6Al-4V alloys consisting of α-Ti grains and intergranular β-Ti islands were nitrided at 850°C for 1 to 12 h under a nitrogen pressure of 1 Pa. With increasing nitriding time, the Ti-N compound layer became thicker, and the α-Ti diffusion zone containing dissolved nitrogen became wider. In the Ti-N compound layer, the initially formed Ti2N became TiN as the nitriding progressed. The nitride l...
متن کاملFabrication and characterization of the Ti-6Al-4V/Mg scaffold
Ti–6Al–4V scaffolds were fabricated by powder metallurgical space holder technique in this research. The most added magnesium (Mg) powder was evaporated and a skeleton of Ti-6Al-4V alloy was produced. For this purpose Ti-6Al-4V and Mg powders mixture compacted in a steel die by applying uniaxial pressure of 500 MPa before sintering the green product in a sealed quartz tubes at 900 °C for 2 hour...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Open Industrial & Manufacturing Engineering Journal
سال: 2009
ISSN: 1874-1525
DOI: 10.2174/1874152500902010001