Machinability of Reinforced Sintered High Speed Steel.
نویسندگان
چکیده
منابع مشابه
Machinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملPrediction of steel machinability by genetic programming
Purpose: This paper describes intelligent system to predict steel machinability. Design/methodology/approach: The prediction of machinability of steel, depending on input parameters (percentage of calcium, percentage of oxygen, percentage of sulphur), was performed by means of genetic programming and data on the batches of steel already made. Findings: The mathematical model to predict machinab...
متن کاملmachinability investigation of inconel 657 in high-speed turning
a high strength nickel chromium alloy (50cr-50ni-nb alloy), commonly referred to as in-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. the purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of inconel 657. the considered parameters...
متن کاملSintered Steel Composites Reinforced with Ceramic Nanoparticles: Fabrication, Characteristics and Wear Behavior
Steel composites reinforced with alumina nanoparticles were prepared by powder metallurgy process. Samples containing two different amounts of carbon (0.35 and 0.55 wt.%) and 0-5 wt.% Al2O3 nanoparticles were fabricated by mixing, compacting and sintering of diffusion bonded Distaloy AE powder. The density, hardness and wear tests were performed on the prepared samples. Fu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1998
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.64.142