Machinability improvement using high-pressure cooling in turning
نویسندگان
چکیده
منابع مشابه
Machinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملMachinability Improvement of 17-4PH Stainless Steel by Cryogenic Cooling
17-4PH stainless steel is a martensitic precipitation hardening stainless steel that provides an outstanding combination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. This valuable alloy is widely used in the aerospace, nuclear, chemical, pet...
متن کاملMachinability Improvement of 17-4PH Stainless Steel by Cryogenic Cooling
17-4PH stainless steel is a martensitic precipitation hardening stainless steel that provides an outstanding combination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. This valuable alloy is widely used in the aerospace, nuclear, chemical, pet...
متن کاملThe Machinability of Nickel-based Alloys in High-pressure Jet Assisted (hpja) Turning
D. Kramar, J. Kopač, Faculty of Mechanical Engineering, University of Ljubljana, Ljubljana, Slovenia M. Sekulić, Faculty of Technical Sciences, University of Novi Sad, Novi Sad, Serbia Z. Jurković, Faculty of Engineering, University of Rijeka, Rijeka, Croatia Due to their mechanical, thermal and chemical properties, nickel-based alloys are generally included among materials that are hard to mac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Research in Agricultural Engineering
سال: 2014
ISSN: 1212-9151,1805-9376
DOI: 10.17221/38/2013-rae