Low‐stress over‐molding of media‐tight electronics using thermoplastic foam injection molding
نویسندگان
چکیده
منابع مشابه
Injection Molding Micro- and Nanostructures in Thermoplastic Elastomers
Amongst the ever-growing toolbox of microand nanofabrication techniques, polymer replication-based processes continue to attract attention due to the conceptual simplicity, reproducibility, and great variety of often cheap materials that can be used. Cost and time saving advantages are further provided by high throughput replication techniques such as roll-to-roll nanoimprint lithography [ 1 ]
متن کاملFault detection in a thermoplastic injection molding process using neural networks
Injection molding technology should assure a high level of quality control of the molded parts in an automated way. Inherent complexities of the process make mathematical modeling di¢cult, hindering the control quality demands of conventional methods. Neural networks adaptive data based technology has been successfully applied in industrial applications since these rely on highly nonlinear mode...
متن کاملImprovements in the Simulation of Orientation in Injection Molding of Short Fiber Thermoplastic Composites
The mechanical properties of injection molded short-fiber reinforced thermoplastic composite parts are highly dependent on the orientation distribution of the fibers. A simulation tool capable of predicting fiber orientation accurately as a function of mold design and processing conditions is required as the predicted fiber orientation capabilities in commercial software show large discrepancie...
متن کاملSimulation of Orientation in Injection Molding of a Highly Concentrated, Short Glass Fiber Thermoplastic Composites
This paper presents a 2D coupled Hele-Shaw flow approximation for predicting the flow-induced orientation of injection molded composite parts within a commercial concentration range. For a highly concentrated short glass fiber PBT suspension, the impact of inter-particle interactions and the orientation at the gate is investigated for a center-gated disk using a time-delayed orientation evoluti...
متن کاملThermoplastic Polymer Shrinkage in Emerging Molding Processes
In this paper, in situ experiments have been designed using the full-field deformation technique of Digital Image Correlation (DIC) to characterize non-uniform shrinkage in thermoplastic polymers commonly used in traditional and emerging molding processes. These experiments are capable of characterizing the differences in strains that develop due to thermal gradients and stiction as the polymer...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer Engineering & Science
سال: 2021
ISSN: 0032-3888,1548-2634
DOI: 10.1002/pen.25672