Low‐cycle fatigue life of thin‐plate auxetic cellular structures made from aluminium alloy 7075‐T651
نویسندگان
چکیده
منابع مشابه
Fatigue and Anisotropic behaviours of cold rolled AA1200 Aluminium Alloy
This study examines the fatigue and anisotropy behaviour of cold rolled AA1200 aluminium alloy for light weight automotive connecting rod application. Aluminium (Al) 1200 ingots were melted at temperature of 680 0C (after one hour of heating) cast in sand mould and cast samples homogenized for 6 hrs at 480 0C. The cold rolling process was carried out after homogenisation for 10, 20, 30, 40 and ...
متن کاملFatigue of Friction Stir Welded 2024-T351 Aluminium Alloy
Fatigue failure characteristics of friction stir welds in 13mm gauge 2024-T351 plate have been assessed. Failure occurred from either the weld region (nugget/flow arm) or from the material immediately surrounding the weld. Fatigue failure from the surrounding material was essentially conventional, initiating from large S-phase intermetallic particles and growing in a macroscopic mode I manner. ...
متن کاملCompressive behavior of age hardenable tetrahedral lattice truss structures made from aluminium
Open cell, lattice truss structures have been made by folding perforated 6061 aluminium alloy sheets. Simple air brazing is used to construct sandwich panels with cellular core relative densities between 0.02 and 0.08. Some panels were quenched and aged while others were tested in an annealed condition. The measured peak compressive strengths varied from 0.7 to 20 MPa, increasing with core rela...
متن کاملHeat Generation during the Fatigue of a Cellular Al Alloy
because of low its thermal conductivity.[5,6] To the authors’ CELLULAR metals have been shown to experience knowledge, there have been no studies either in metals or fatigue degradation in both tension and compression.[1,2] This polymers of heat generated locally around stationary cracks degradation is manifested as a rapid increase in strain after subject to cyclic loading. a quiescent nucleat...
متن کاملThe Effects of Surface Pretreatment on the Cyclic-Fatigue Characteristics of Bonded Aluminium-Alloy Joints
The present work has used an accelerated test method, based upon cyclic-fatigue testing using a fracture-mechanics approach, to study the durability of organosilanepretreated joints which were adhesively-bonded using a hot-cured epoxy-film adhesive. The silane primer investigated was γ-glycidoxypropyltrimethoxysilane (GPS). The cyclic-fatigue tests were mainly conducted in (a) a ‘dry’ environme...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Fatigue & Fracture of Engineering Materials & Structures
سال: 2019
ISSN: 8756-758X,1460-2695
DOI: 10.1111/ffe.12966