Low-voltage Power Supply Subsystem for a Sub-Orbital Particle Physic Instrument
نویسندگان
چکیده
منابع مشابه
Variable Supply Voltage for Low Power DSP
The use of dynamically adjustable power supplies as a method to lower power dissipation in DSP is analyzed. Power can be cut substantially without sacrificing performance in applications where the computational workload changes with time. If latency can be tolerated, buffering data and averaging processing rate can yield further power reduction. Continuous variation of the supply voltage can be...
متن کاملWorkload-aware low-power supply voltage controller
Current microprocessors are complex systems with multiple cores and non-trivial architectures, employing millions of sub-100nm transistors designed for extreme power, speed, and reliability constraints.1 An efficient control scheme for dynamic power, reliability, error detection-correction, workload scheduling, and thermal management is required. However, neuromorphic architectures are currentl...
متن کاملSupply and Threshold Voltage Scaling for Low Power CMOS
This paper investigates the effect of lowering the supply and threshold voltages on the energy efficiency of CMOS circuits. Using a first-order model of the energy and delay of a CMOS circuit, we show that lowering the supply and threshold voltage is generally advantageous, especially when the transistors are velocity saturated and the nodes have a high activity factor. In fact, for modern subm...
متن کاملSampled-data operational-amplifier with ultra-low supply voltage and sub µW power consumption
This paper proposes the use of sampled-data operation in op-amps. The technique favors very low supply voltage and micro-power. After discussing the method at a general level, a possible sampled-data scheme is analyzed. Simulations with a low threshold technology show that a 0.5-V supply is possible. A version of the circuit, which has been integrated by using a standard 0.18-μm CMOS technology...
متن کاملDesign of a minimum power , low - voltage supply fully
{ Two designs of a fully diierential transconductance ampliier to be used in a rst stage of a pipelined 13-Bit A/D converter are developed and presented. A three stage ampliier achieves the lowest power design. The dynamic range speciication is met according to the expression for noise power indicated in the design speciication sheet. In this report, anyway, we show that such expression is inco...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Electrical and Electronic Engineering
سال: 2014
ISSN: 1804-3119,1336-1376
DOI: 10.15598/aeee.v12i3.1074