Low Temperature Sintering of Cu-substituted YIG.
نویسندگان
چکیده
منابع مشابه
Low temperature spark plasma sintering of YIG powders Authors: L. Fernandez-Garcia
A transition from a low to a high spin state in the magnetization saturation between 1000 and 1100 oC calcination temperature is observed in YIG powders prepared by oxides mixture. Spark plasma sintering of these powders between 900 and 950 oC leads to dense samples with minimal formation of YFeO3, opening the way to cosintering of YIG with metals or metallic alloys. The optical properties depe...
متن کاملSize control of Cu nanorods through oxygen-mediated growth and low temperature sintering.
Control of the size of Cu nanorods vapor-deposited at an oblique angle (approximately 85 degrees) by oxygen-mediated growth was investigated using scanning electron microscopy (SEM) and x-ray diffraction (XRD). It was observed that exposure of Cu nanorods to the oxygen ambient periodically resulted in a reduction in the diameter of the nanorods as well as an increase in the areal density of the...
متن کاملLow Temperature Sintering Additives for Silicon Nitride
This work deals with sintering additives for the low temperature pressureless sintering of Si3N4, via a transient liquid technique. Much attention has been given to the development of a sintering process using low-cost Si3N4 powder (Silzot HQ, Germany) as the starting material and employing sintering additives which are also both economically attractive and enable sintering at low temperatures....
متن کاملLow-temperature sintering of MnO2-doped PZT–PZN Piezoelectric ceramics
The effect of MnO2 addition on the microstructural evolution and piezoelectric properties of low temperature sinterable PZT–PZN ceramics was investigated. When a small amount of MnO2 (≤0.5 wt% ) was added, the Mn ions were homogeneously dissolved in the PZT– PZN ceramics, leading to full densification at a temperature as low as 930 °C. However, the further addition of MnO2 hindered the densific...
متن کاملLow-Temperature and Low-Pressure Cu–Cu Bonding by Highly Sinterable Cu Nanoparticle Paste
A reliable Cu-Cu bonding joint was achieved by using the highly sinterable Cu nanoparticle paste. Pure copper nanoparticles used in the preparation of nanoparticle paste were synthesized through simple routes, with an average size of 60.5 nm. Under an Ar-H2 gas mixture atmosphere, the Cu nanoparticle paste exhibited large areas of fusion after sintering at 300 °C and reached a low electrical re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2002
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.49.95