Low-Range Differential Pressure Transducer Using Unbonded Strain Gauge Filaments and Thin Diaphragm
نویسندگان
چکیده
منابع مشابه
A Strain Gauge Torque Transducer Calibration Study
-This paper presents for the study of torque transducer (torque sensor) calibration built into a rotating shaft, in this case uses strain gauge, which was done with, and the output signal of the "voltage (mV/V)" has been taken for each weight, increasing and decreasing the weights. The data have been taken three times which they have been divided into three series. First and foremost, the avera...
متن کاملIntra-arterial Pressure Measurement with Strain Gauge and Amplifier *
The purpose of this paper is briefly to describe intra-arterial pressure recording by means of a strain gauge pressure transducert and amplifiers. The use of resistance wire strain gauges for blood pressure recording with galvanometers has already been described.1"8 The use of the strain gauge with electronic amplification as a plethysmograph has also been described.2 Since alternating input cu...
متن کاملCold pressor test using strain-gauge plethysmography.
This laboratory activity is designed to teach students how to measure forearm muscle blood flow (FBF) to describe the mechanisms of peripheral blood flow thermal regulation in healthy subjects. The cold pressor test (CPT) is the clinical procedure used in the experiment to induce arterial vasoconstriction. Strain-gauge plethysmography is applied on the patient's forearm to noninvasive monitor v...
متن کاملSubnanowatt Microbubble Pressure Transducer
We present the first all-Parylene microbubble pressure transducer (μBPT). The μBPT utilizes an electrolytically generated microbubble (μB), trapped in a Parylene microchamber, for pressure sensing. Pressure-induced bubble size variation is detected by electrochemical impedance measurement. Real-time hydrostatic pressure measurement with excellent sensitivity (-10.7 Ω/psi, ±0.1 psi) up to 1.8 ps...
متن کاملAccurate measurements of the thermal diffusivity of thin films and thin filaments using lock-in thermography
In lock-in thermography the thermal diffusivity can be obtained from the slope of the linear relation between the phase of the surface temperature and the distance to the heating spot. However, in the case of thin samples, the linearity is not found. In this work we identify heat conduction to the surrounding gas as the mechanism responsible for the lost of linearity. Accordingly accurate measu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Society of Instrument and Control Engineers
سال: 1971
ISSN: 0453-4654
DOI: 10.9746/sicetr1965.7.359