Low Pressure Amalgam Bactericidal Lamps

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Breakdown characteristics of high pressure xenon lamps

An investigation of the breakdown of high intensity discharge (HID) lamps filled with xenon at pressures from 0.1 to 5 bar is presented. Three power supplies were used in order to provide voltage rates of increase covering about four orders of magnitude from 5 mV ns−1 to 100 V ns−1, the latter being typical for electronic ballasts driving commercial HID lamps. Customized lamps ensure a volume b...

متن کامل

High Power Factor Electronic Ballast for High Pressure Sodium Lamps With Low Crest Factor

In this paper will be reported the study and implementation of a single stage High Power Factor (HPF) electronic ballast for High Pressure Sodium (HPS) lamps using a Half-Bridge Boost Rectifier integrated with an Electronic Ballast based in a LCC filter. In the recent years many authors are working to obtain single stage HPF electronic ballast for fluorescent lamps [1-3]. Normally to obtain HPF...

متن کامل

A Low Cost Single Stage Electronic Ballast Family For High Pressure Sodium Lamps

In the recent years many authors [1-4] are working to obtain single stage HPF electronic ballast for fluorescent and HID lamps to obtain cost reduction and to comply with international standard requirements. Usually to obtain HPF in electronic ballast for high pressure sodium lamps a Power Factor Preregulator (PFP) is used between the mains and the electronic ballast [5]. In this paper will be ...

متن کامل

Endotoxin inactivation in water by using medium-pressure UV lamps.

Deionized water was spiked with various concentrations of endotoxin and exposed to UV irradiation from medium-pressure UV lamps to assess endotoxin inactivation. It was found that endotoxin inactivation was proportional to the UV dose under the conditions examined. The inactivation rate was determined to be approximately 0.55 endotoxin unit/ml per mJ/cm(2) of irradiation delivered.

متن کامل

Zinc and sodium high pressure lamps for curing composite resins.

Polymerisation characteristics of conventional units for curing composite resins are insufficient considering handling feasibilities particularly in the premolar and molar region. There is also hazardous ocular effect of near ultra-violet part of visible spectra. Sodium high pressure lamp technology has been applied to develop a new high pressure zinc lamp, which is for the first time used for ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: HELIX

سال: 2019

ISSN: 2277-3495,2319-5592

DOI: 10.29042/2019-4855-4857