Low power shaper amplifier for the EOS TPC detector
نویسندگان
چکیده
منابع مشابه
The Design Aspects for Ultra Low-Power, Low-Noise 90 nm CMOS Charge Sensitive Amplifier for the Active Pixel Detector
A falling particle in the digital registration systems for elementary particles active pixel detector induces electric charge, the value of which describes the parameters of the particle in the detector. Since the electric charge induced by a single particle is relatively weak, the detector signal is first processed (amplified and shaped) right in the zone of irradiation and only then transmitt...
متن کاملFast TRD Pre-Amplifier Shaper for the CBM experiment
In order to achieve an overall noise of less than 1000 electrons per channel for a typical input capacitance of a total of 5-10 pF, the use of a low-noise circuit is required. A well proven topology to fulfil such a requirement is shown in fig. 1. Each channel consist of a low noise chargesensitive amplifier, an active CR-(RC) pulse shaper. The main noise contributor is the input transistor of ...
متن کاملFront-End Electronics for a TPC-Detector
The CERES/NA45-Collaboration upgrades the existing lepton-pair spectrometer at the CERN SPS with a TPC detector which improves the momentum resolution. We present the development of new front-end electronics to read out the nearly 20000 channels of the chamber. It is comprised of two circuits: (i) A continuously sensitive preamplifier with semi-Gaussian shaper and tailcancellation, which offers...
متن کاملA Class E Power Amplifier with Low Voltage Stress
A new output structure for class E power amplifier (PA) is proposed in this paper. A series LC resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. This resonator causes low impedance at the second harmonic. The output circuit is designed to shape the switch voltage of the class E amplifier and lower the voltage stress of the transistor. T...
متن کاملLow-power Adaptive Bipolar Low Noise Amplifier
In this paper, a low-power adaptive low noise amplifier (LNA) is presented. The LNA is based on a bipolar cascode topology, uses inductive source degeneration and emitter area scaling to achieve noise and input-impedance matching simultaneously. The input impedance and the noise factor were simulated as function of the bias collector current and the results show that both are approximately cons...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Nuclear Science
سال: 1991
ISSN: 0018-9499,1558-1578
DOI: 10.1109/23.289261