Low power high performance level converter for dual supply voltage systems
نویسندگان
چکیده
منابع مشابه
A Four-Transistor Level Converter for Dual-Voltage Low-Power Design
Power dissipation in digital circuits has become a primary concern in electronic design. With increasing usage of portable devices, there are severe restrictions being placed on the size, weight and power of batteries. In this work, we propose a design of a dual Vth feedback type four-transistor level converter (DVF4) with reduced delay and power overheads. The use of DVF4 enhances the effectiv...
متن کاملLow-Voltage and Low-Power CMOS Voltage-to-Current Converter
A CMOS voltage-to-current converter in weak inversion is presented in this Letter. It can operate for low supply voltage and its power consumption is also low. As the input voltage varies from −0.15 V to 0.15 V, the measured maximum linearity error for the proposed voltageto-current converter, is about 3.35%. Its power consumption is only 26 μW under the supply voltage of 2 V. The proposed volt...
متن کاملVariable Supply Voltage for Low Power DSP
The use of dynamically adjustable power supplies as a method to lower power dissipation in DSP is analyzed. Power can be cut substantially without sacrificing performance in applications where the computational workload changes with time. If latency can be tolerated, buffering data and averaging processing rate can yield further power reduction. Continuous variation of the supply voltage can be...
متن کاملA High Efficiency Low-Voltage Soft Switching DC–DC Converter for Portable Applications
This paper presents a novel control method to improve the efficiency of low-voltage DC-DC converters at light loads. Pulse Width Modulation (PWM) converters have poor efficiencies at light loads, while pulse frequency modulation (PFM) control is more efficient for the same cases. Switching losses constitute a major portion of the total power loss at light loads. To decrease the switching losses...
متن کاملDesign of High Voltage Low Power Supply Device
The objectives of this paper are to investigate and develop a device that will produce high voltage low power supply. Generation of high voltage low power supply can be determined by using Flyback converter as an optimum method which can improve the design of the device to make it smaller in size, simpler and cost effective. In this paper, the device circuits are simulated using PSPICE software...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2007
ISSN: 1349-2543
DOI: 10.1587/elex.4.306