Low power design of wireless endoscopy compression/communication architecture
نویسندگان
چکیده
منابع مشابه
Design Methodologies for Low Power VLSI Architecture
Present generation of electronic design scenario demands low power architectures. In earlier days, power was secondary as the field was premature and main concerns of design engineers were size, throughput and cost. However trade off exists between the metrics namely, size, throughput, cost and power according to the famous design metric competition theory of VLSI systems wherein improving one ...
متن کاملLow Power Design for Wireless Sensor Networks
Reference design for radio part is OKI’s ML7050LA [2] single chip RF having for example following blocks integrated: Low noise amplifier (LNA), power amplifier (PA), image rejection mixer (IMR). Block diagram of ML7050LA is in Figure 1. By assuming to use 3 V supply voltage Tx power dissipation is 102mW and Rx power dissipation is 165mW. Abstract—Wireless sensor networks have several challenges...
متن کاملHYREP: A Hybrid Low-Power Protocol for Wireless Sensor Networks
In this paper, a new hybrid routing protocol is presented for low power Wireless Sensor Networks (WSNs). The new system uses an integrated piezoelectric energy harvester to increase the network lifetime. Power dissipation is one of the most important factors affecting lifetime of a WSN. An innovative cluster head selection technique using Cuckoo optimization algorithm has been used in the desig...
متن کاملLow Power Architecture for Wireless Applications: A Survey
Applications such as mobile devices (cellular phones, PDA, consumer electronics) does require both a very powerful processor(s) as well as low power consumption because of the limited power supply on such a device (batteries). Saving power can be achieved on three different levels. Firs, it could be achieved through low power VLSI technology where the transistors consume less power for switchin...
متن کاملRF low power subsampling architecture for wireless communication applications
With the increasing demands of wireless communication, flexible, complex, and diversified wireless communication applications are required. However, the difficulty of enabling new wireless communication applications is the lack of low power radio frequency (RF) transmission devices, especially the RF receiver. In order to alleviate this problem, an RF low power subsampling architecture for wire...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electrical Systems and Information Technology
سال: 2018
ISSN: 2314-7172
DOI: 10.1016/j.jesit.2017.01.006