Low Power BiCMOS SRAM using 0. 18µm Technology
نویسندگان
چکیده
منابع مشابه
250nm Technology Based Low Power SRAM Memory
High integration density, low power and fastperformance are all critical parameters in designing of memory blocks. Static Random Access Memories (SRAMs)’s focusing on optimizing dynamic power concept of virtual source transistors is used for removing direct connection between VDD and GND. Also stacking effect can be reduced by switching off the stacktransistors when the memory is ideal and the ...
متن کاملUltralow-power SRAM technology
An ultralow-standby-power technology has been developed in both 0.18m and 0.13m lithography nodes for embedded and standalone SRAM applications. The ultralow-leakage sixtransistor (6T) SRAM cell sizes are 4.81 m and 2.34 m, corresponding respectively to the 0.18m and 0.13m design dimensions. The measured array standby leakage is equal to an average cell leakage current of less than 50 fA per ce...
متن کاملDesign of Low Power Sram Memory Using 8t Sram Cell
Low power design has become the major challenge of present chip designs as leakage power has been rising with scaling of technologies. As modern technology is spreading fast, it is very important to design low power, high performance, and fast responding SRAM (Static Random Access Memory) since they are critical component in high performance processors. The Conventional 6T SRAM cell is very muc...
متن کامل6T SRAM at 45nm CMOS technology for low power optimization
SRAM is designed to provide an interface with CPU and to replace DRAMs in systems that require very low power consumption. Low power SRAM design is crucial since it takes a large fraction of total power and die area in high performance processors. A SRAM cell must meet the requirements for the operation in submicron/nano ranges. 8T SRAM is traditionally concerned as a more reliable memory cell,...
متن کاملDesign and Performance Analysis of Low Power RF Operational Amplifier using CMOS and BiCMOS Technology
This paper presents the design and performance comparison of a two stage operational amplifier topology using CMOS and BiCMOS technology. This conventional op amp circuit was designed by using RF model of BSIM3V3 in 0.6 μm CMOS technology and 0.35 μm BiCMOS technology. Both the op amp circuits were designed and simulated, analyzed and performance parameters are compared. The performance paramet...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Computer Applications
سال: 2013
ISSN: 0975-8887
DOI: 10.5120/12547-9128