Low-Penalty Band-Switchable Multi-Band Optical Cross-Connect Using PPLN-Based Inter-Band Wavelength Converters
نویسندگان
چکیده
In multi-band optical networks, a band-switchable cross-connect (MB-OXC), which enables not only the output port but also wavelength band of input signals to be switched, can significantly increase accommodated traffic volume. An all-optical inter-band converter (AO-WC) is key device achieve MB-OXC and required have little signal degradation even when pass through it many times. this paper, we propose low-penalty using AO-WCs with periodically poled lithium niobate (PPLN) waveguides. The PPLN-based AO-WC high conversion efficiency (∼10 dB) low noise figure (∼5 for wavelength-band between entire C-band L-band over 4.8 THz. addition, experimentally evaluate quality 96-channel 32-Gbaud DP-16QAM WDM by AO-WCs. By optimizing power AO-WC, shown that improve volume achieved after > 20 conversions. These results confirm physical-layer feasibility
منابع مشابه
Optical wavelength converters for photonic band gap microcircuits
We demonstrate compact optical wavelength conversion architecture for picosecond laser pulses and data streams within photonic band gap waveguides. These multimode waveguides are seeded with resonantly driven, inhomogeneously broadened, distributions of quantum dots whose optical transition center frequency is placed near a sharp discontinuity in the local electromagnetic density of states LDOS...
متن کاملLow-Loss Matching Network Design for Band-Switchable Multi-Band Power Amplifier
This paper presents a novel design scheme for a bandswitchable multi-band power amplifier (BS-MPA). A key point of the design scheme is configuring multi-section reconfigurable matching networks (MR-MNs) optimally in terms of low loss matching in multiple frequency bands from 0.7 to 2.5 GHz. The MR-MN consists of several matching sections, each of which has a matching block connected to a trans...
متن کاملRefractive Dual Band Infrared Imager Optical Design
Infrared imagers are important for reorganization and monitoring. This paper discusses the design of an infrared imager. Optical design in medium wavelength infrared (MWIR) and long wavelength infrared (LWIR) bands is different and needs distinct detectors and materials. Reflective systems are not suitable due to their small field of view (FOV) and vignetting. Refractive dual band optical syste...
متن کاملDesign of an S-band Ultra-low-noise Amplifier with Frequency Band Switching Capability
In this paper, an ultra-low-noise amplifier with frequency band switching capability is designed, simulated and fabricated. The two frequency ranges of this amplifier consist of the 2.4 to 2.5 GHz and 3.1 GHz to 3.15 GHz frequency bands. The designed amplifier has a noise figure of less than 1dB, a minimum gain of 23 dB and a VSWR of less than 2 in the whole frequency band. The design process s...
متن کاملLow Power Band to Band Tunnel Transistors
Permission to make digital or hard copies of all or part of this work for personal or classroom use is granted without fee provided that copies are not made or distributed for profit or commercial advantage and that copies bear this notice and the full citation on the first page. To copy otherwise, to republish, to post on servers or to redistribute to lists, requires prior specific permission....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Lightwave Technology
سال: 2023
ISSN: ['0733-8724', '1558-2213']
DOI: https://doi.org/10.1109/jlt.2023.3302475