Low Noise and high linearity Wide-band Low Noise Amplifier for 5G Receiver Front End System
نویسندگان
چکیده
منابع مشابه
A Concurrent Dual-Band Low Noise Amplifier for GNSS Receivers
In this paper, a new design of concurrent dual-band Low Noise Amplifier (LNA) for multi-band single-channel Global Navigation Satellite System (GNSS) receivers is proposed. This new structure is able to operate concurrently at frequency of 1.2 and 1.57 GHz. Parallel and series resonance parts are employed in the input matching in order to achieve concurrent performance. With respect to used pse...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملA Low Noise Amplifier Optimized for a GPS Receiver RF Front End
A cascode LNA was optimized for a GPS receiver radio frequency front end using a 0.18 μm CMOS technology. By careful choice of device geometry, gate and source degeneration inductors, a fully integrated LNA can be optimized to have a low noise figure, a high voltage gain and a wide dynamic range. The optimized LNA has a 1.512 dB noise figure, a –42.05 dB S11, a 20.04 dB voltage gain a –19.82 dB...
متن کاملA low noise amplifier with improved linearity and high gain
In this paper presents a optimization of linearity of low noise amplifier by using post linearization techniques. in this technique we have used diode connected mosfet as IMD sinker also used interstage matching for gain enhancement and reducing the effect of nonlinearity in common gate stage of cascode amplifier, this has done by using UMC .18um CMOS Technology in cadence tool. We got gain 14d...
متن کاملActive Inductor based Low Noise Amplifier for Ultra Wide Band Receiver
In this paper a three stage Active Inductor (AI) based Low Noise Amplifier (LNA) for Ultra Wide Band (UWB) receiver is presented. A fully differential topology has been adopted in order to improve the circuit robustness against unwanted common mode signals. T-coil peaking is used to enhance the bandwidth over the entire Ultra Wide Band frequency range. Active inductor is employed because of its...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: regular
سال: 2021
ISSN: 2278-3075
DOI: 10.35940/ijitee.f8718.0410621