Low input-resistance low-power transimpedance amplifier design for biomedical applications

Low Noise Low Power Transimpedance Amplifier in 0.18μm Cmos Technology

Low noise and low Power transimpedance amplifiers (TIA) are essential modules for optical sensor based systems. But low power and low noise TIAs are still a challenge for the scientists despite of rapid advances in complementary metal oxide semiconductor (CMOS) technology. This paper proposes a three-stage nested miller compensated (NMC) based design of low noise low power transimpedance amplif...

A Low-Voltage, Low-Power, Two-Stage Amplifier for Switched-Capacitor Applications in 90 nm CMOS Process

Abstract- A novel low-voltage two-stage operational amplifier employing resistive biasing is presented. This amplifier implements neutralization and correction common mode stability in second stage while employs capacitive dc level shifter and coupling between two stages. The structure reduces the power consumption and increases output voltage swing. The compensation is performed by simple mill...

Low-cost Vector Network Analyzer for Biomedical Applications

A low-cost and portable vector network analyzer (VNA) which covered operating frequency between 1MHz to 3GHz is used for vector reflection coefficient and standing wave ratio (swr) of the various microstrip antennas. This paper presents measurements of various ultra wideband (uwb) microstrip antennas for applications in biomedical field. Selection of antenna is an important key for detection of...

Wideband Wireless Power Transmission to Enhance Efficiency for Low Input Power for Biomedical Applications

Design of a Current Mirror Based Differential Amplifier for Low-voltage and Low Power Applications

As per the Moore’s law, there is an extreme increase in number of on chip devices, this increase in chip density results in power dissipation and thus the power utilization is unsatisfactory. So to avoid this problem the concept of Low Power system arises. As a part of microelectronics, it has been proposed to make the choice of minute circuit with attraction added by use of MOS cells. Since we...