Low-Frequency Noise in CMOS Switched-gm Mixers: A Quasi-Analytical Model
نویسندگان
چکیده
منابع مشابه
High-Frequency Noise in RF Active CMOS Mixers
A new analytical model for high-frequency noise in RF active CMOS mixers such as single-balanced and doublebalanced architectures is presented. The analysis includes the contribution of non-white gate-induced noise at the output as well as the spot noise figure (NF) of the RF CMOS mixer, while accounting for the non-zero correlation between the gateinduced noise and the channel thermal noise. T...
متن کاملBroadband Low-Noise CMOS Mixers for Wireless Communications
In this thesis, three broadband low-noise mixing circuits which use CMOS 130 nm technology are presented. As one of the first few stages in a receiving front-end, stringent requirements are posted on mixer performance. The Gilbert cell mixers have presented excellent properties and achieved wide applications. However, the noise of a conventional active Gilbert cell mixer is high. This thesis de...
متن کاملNoise in Current-Commutating CMOS Mixers
A noise analysis of current-commutating CMOS mixers, such as the widely used CMOS Gilbert cell, is presented. The contribution of all internal and external noise sources to the output noise is calculated. As a result, the noise figure can be rapidly estimated by computing only a few parameters or by reading them from provided normalized graphs. Simple explicit formulas for the noise introduced ...
متن کاملLow Frequency Noise in Cmos Transistors
Title of dissertation: LOW FREQUENCY NOISE IN CMOS TRANSISTORS Anshu Sarje, Doctor of Philosophy, 2013 Dissertation directed by: Professor Martin Peckerar Department of Electrical and Computer Engineering The minimum measurable signal strength of an electronic system is limited by noise. With the advent of very large scale integrated (VLSI) systems, low power designs are achieved by reducing th...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2020
ISSN: 2169-3536
DOI: 10.1109/access.2020.3032297