LOW DENSITY POLYETHYLENE (LDPE) NANOCOMPOSITES WITH PASSIVE AND ACTIVE BARRIER PROPERTIES
نویسندگان
چکیده
منابع مشابه
Oxygen-barrier films based on low-density polyethylene/ ethylene vinyl alcohol/ polyethylene-grafted maleic anhydride compatibilizer
In this research, high oxygen-barrier films were organized based on low-density polyethylene (LDPE)/ ethylene vinyl alcohol (EVOH)/ polyethylene-grafted maleic anhydride (LDPE-g-MA) compatibilizer. The effects of 10–30 wt. % EVOH and 0–10 wt. % LDPE-g-MA loadings on the properties of final films were evaluated. The morphology of specimens was observed by using scanning electron microscopy (SEM)...
متن کاملThermal-insulation performance of low density polyethylene (LDPE) foams: Comparison between two radiation thermal conductivity models
The loss of energy especially in industrial and residential buildings is one of the main reasons of increased energy consumption. Improving the thermal insulation properties of materials is a fundamental method for reducing the energy losses. Polymeric foams are introduced as materials with excellent thermal insulation properties for this purpose. In the present study, a deep theoretical invest...
متن کاملModeling and Simulation of Low Density Polyethylene (LDPE) High Pressure Tubular Reactor
Low Density Polyethylene (LDPE) is produced by free radical polymerization. Industrially, LDPE polymerization process is usually carried out in a continuous mode (tubular or autoclave reactors) at high pressures (1300-3400 atm) and temperatures (50-340 0 C). LDPE exhibits a number of desirable properties, including high tensile strength, flexibility, high impact resistance, low crystallinity, l...
متن کاملFractional Distillation Process Utilized to Produce Light Fractional Fuel from Low Density Polyethylene (LDPE) Waste Plastic
Plastics are not easily biodegradable; and because of these characteristics they can remain under landfill and water for a very long period of time. All over the world only 6% of waste plastics are recycled and the rest of all waste plastics are dumped into landfills. An experiment was conducted in a laboratory scale batch process under Labconco’s fume hood utilizing low density polyethylene (L...
متن کاملOptimization of Injection Moulding Process Parameters in the Moulding of Low Density Polyethylene (LDPE)
Injection moulding is one of the most popular polymer processing methods due to its high production rate as well as its ability to produce very intricate geometries at very cheaper cost and within few seconds. There are several flaws which occur while producing plastic parts by Injection moulding, like warpage, shrinkage, flash, sink marks etc. Shrinkage is one of the most critical problems whi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Chilean Chemical Society
سال: 2014
ISSN: 0717-9707
DOI: 10.4067/s0717-97072014000200009