منابع مشابه
Development of a 3D printer using scanning projection stereolithography
We have developed a system for the rapid fabrication of low cost 3D devices and systems in the laboratory with micro-scale features yet cm-scale objects. Our system is inspired by maskless lithography, where a digital micromirror device (DMD) is used to project patterns with resolution up to 10 µm onto a layer of photoresist. Large area objects can be fabricated by stitching projected images ov...
متن کاملLow-cost Vector Network Analyzer for Biomedical Applications
A low-cost and portable vector network analyzer (VNA) which covered operating frequency between 1MHz to 3GHz is used for vector reflection coefficient and standing wave ratio (swr) of the various microstrip antennas. This paper presents measurements of various ultra wideband (uwb) microstrip antennas for applications in biomedical field. Selection of antenna is an important key for detection of...
متن کاملDlp
DLP (for Description Logic Prover) is a description logic system that contains a sound and complete rea-soner for an expressive description logic. DLP is an experimental system, in that it does not contain all the support facilities that one might like in a full description logic system. However, DLP does have an interface that allows the creation and examination of taxonomies of concepts. DLP ...
متن کاملDimensional Error in Rapid Prototyping with Open Source Software and Low-cost 3D-printer
Rapid prototyping models (RPMs) had been extensively used in craniofacial and maxillofacial surgery, especially in areas such as orthognathic surgery, posttraumatic or oncological reconstructions, and implantology. Economic limitations are higher in developing countries such as Mexico, where resources dedicated to health care are limited, therefore limiting the use of RPM to few selected center...
متن کاملLow cost lab-on-a-chip prototyping with a consumer grade 3D printer.
Versatile prototyping of 3D printed lab-on-a-chip devices, supporting different forms of sample delivery, transport, functionalization and readout, is demonstrated with a consumer grade printer, which centralizes all critical fabrication tasks. Devices cost 0.57US$ and are demonstrated in chemical sensing and micromixing examples, which exploit established principles from reference technologies.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Strojniški vestnik - Journal of Mechanical Engineering
سال: 2017
ISSN: 0039-2480,0039-2480
DOI: 10.5545/sv-jme.2017.4591