Loosening of Surface Rock and Slope Failure
نویسندگان
چکیده
منابع مشابه
Fractal rock slope dynamics anticipating a collapse.
Time series of dilatometric measurements of relative displacements on rock cracks on stable and unstable sandstone slopes were analyzed. The inherent dynamics of rock slopes lack any significant nonlinearity. However, the residuals obtained by removing meteorological influences are fat-tailed non-Gaussian fluctuations, with short-range correlations in the case of stable slopes. The fluctuations...
متن کاملSystem reliability approach to rock slope stability
A systematic quantitative methodology for the reliability analysis of stability of rock slopes is presented. A sliding mass resting on an inclined plane and composed of two blocks separated by a vertical tension crack is considered, and a disjoint cut-set system formulation is proposed, with each cut-set corresponding to a different failure mode of the slope. Methods for the evaluation of the s...
متن کاملBack analyses for slope failures in rock
Some of the geotechnical parameters used in the analysis may not be accurately measured directly from laboratory tests due to effects of sample disturbance and errors of tests. The back analysis or the observational method are thus often applied to determine the representative and/or dominant strength parameters based on field observations in practice. Based on the Hoek-Brown failure criterion,...
متن کاملRock slope discontinuity extraction and stability analysis from 3D point clouds: application to an urban rock slope
This paper presents an application of a recently developed methodology for the identification and analysis of flat surfaces affecting rock masses using 3D LiDAR point clouds(Riquelme et al., 2013 submited). The used methodology has been applied to calculate the algebraic equations of the different discontinuities of a rock slope through a methodology based on next three steps: (a) local curvatu...
متن کاملInfluence of modeling material on undercut slope failure mechanism
A series of physical modeling tests were conducted by means of a beam type geotechnical centrifuge machine in order to investigate the drainage impact on the slope failure mechanism under centrifugal acceleration. Meanwhile, the phenomenon of stress redistribution in undercut slopes and the formation of arching effect were studied. For this purpose, a poorly graded sandy soil (Silica sand No. 6...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Geography (Chigaku Zasshi)
سال: 1987
ISSN: 0022-135X,1884-0884
DOI: 10.5026/jgeography.95.7_496