Local time-averaged gas holdup in fluidized bed reactor using gamma ray computed tomography technique (CT)
نویسندگان
چکیده
منابع مشابه
Using X-ray computed tomography to measure local gas holdup in a stirred tank reactor
Gas holdup is one of the most important hydrodynamic parameters needed for reliable design, performance estimation, and scale-up of stirred tank reactors (STRs). In the present work, local gas holdup is measured in an acrylic stirred tank reactor equipped with a Rushton impeller using X-ray computed tomography (CT) for many different operating conditions. Power consumption for different operati...
متن کاملJetting Visualization in an Acoustic Fluidized Bed Using X - Ray Computed Tomography
Introduction Understanding the jetting phenomena near the gas distributor plate in a fluidized bed is important to gassolids mixing, heat and mass transfer, and erosion on any bed internals, which can all affect the performance of the bed. Moreover, acoustic vibration in a fluidized bed can be used to enhance the fluidization quality of particulate matter. Visualizing the jetting structure usin...
متن کاملCFD Modeling of Cold-Flow Fluidized Beds and Validation with X-ray Computed Tomography
The hydrodynamics in a 152 mm ID bubbling fluidized bed filled with 500-600 μm glass beads have been simulated using the computational fluid dynamics (CFD) code Fluent 6.3, and the results are compared to experimental data obtained using pressure measurements and 3D X-ray computed tomography. The grids in a Cartesian coordinate system used in simulations are made by 2D (8×8 mm, 4×4 mm, 2×2 mm, ...
متن کاملDetermination of optimum gas holdup conditions in a three-phase fluidized bed by genetic algorithm
Experiments have been carried out in a 0.1 m internal diameter, 1.88 m height vertical Plexiglas column with an antenna type modified air sparger in the gas-liquid distributor section. This arrangement provides uniform mixing of the fluids, ensures the gas entering the fluidizing section as fine bubbles and reduces the pressure drop encountered through a conventional distributor used for the pu...
متن کاملModeling a Biomass Fluidizing Bed With Side Port Air Injection
Fluidized beds are used to gasify materials such as coal or biomass in the production of producer gas. Modeling these reactors using computational fluid dynamics is advantageous when performing parametric studies for design and scale-up. While two-dimensional simulations are easier to perform than threedimensional simulations, they may not capture the proper physics. This paper compares twoand ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Industrial Chemistry
سال: 2015
ISSN: 2228-5970,2228-5547
DOI: 10.1007/s40090-015-0048-6