Load carrying capacity of ice-strengthened frames under idealized ice load and boundary conditions
نویسندگان
چکیده
منابع مشابه
Load Carrying Capacity of Simply Supported Variable Thickness Circular Plates
The calculation of the load carrying capacity of variable thickness circular plates subjected to arbitrary rotational symmetric loading is presented. The analysis considers plate materials that obey either the square or the Tresca yield criterion. By using upper and lower bound theorems of limit analysis, corresponding estimations for the load carrying capacity of the plate are obtained. It is ...
متن کاملUnder-ice Boundary Layer
Sea ice is in almost constant motion in response to wind, ocean currents, and forces transmitted within the ice cover itself, thus there is nearly always a zone of sheared Sow between the ice and underlying, undisturbed ocean where turbulence transports momentum, heat, salt, and other contaminants vertically. The zone in which these turbulent Suxes occur, which can span from a few to hundreds o...
متن کاملOptimal Trajectory of Flexible Manipulator with Maximum Load Carrying Capacity
In this paper, a new formulation along with numerical solution for the problem of finding a point-to-point trajectory with maximum load carrying capacities for flexible manipulators is proposed. For rigid manipulators, the major limiting factor in determining the Dynamic Load Carrying Capacity (DLCC) is the joint actuator capacity. The flexibility exhibited by light weight robots or by robots o...
متن کاملLoad-carrying capacity of the human cervical spine in compression is increased under a follower load.
STUDY DESIGN An experimental approach was used to test human cadaveric cervical spine specimens. OBJECTIVE To assess the response of the cervical spine to a compressive follower load applied along a path that approximates the tangent to the curve of the cervical spine. SUMMARY OF BACKGROUND DATA The compressive load on the human cervical spine is estimated to range from 120 to 1200 N during...
متن کاملDynamic Load Carrying Capacity of Flexible Manipulators Using Finite Element Method and Pontryagin’s Minimum Principle
In this paper, finding Dynamic Load Carrying Capacity (DLCC) of flexible link manipulators in point to-point motion was formulated as an optimal control problem. The finite element method was employed for modelling and deriving the dynamic equations of the system. The study employed indirect solution of optimal control for system motion planning. Due to offline nature of the method, many diffic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Marine Structures
سال: 2018
ISSN: 0951-8339
DOI: 10.1016/j.marstruc.2017.10.011