Load Capacity of Polyacetal(POM)Internal Gears
نویسندگان
چکیده
منابع مشابه
Evaluation of load capacity of gears with an asymmetric tooth profile
Background: An ISO standard tooth profile has a symmetric pressure angle of 20°. However, the load capacity can be increased with respect to bending and contact pressure by increasing the pressure angle on the meshing side of an asymmetric tooth. Accordingly, we analyzed the torque transmission capacity of asymmetric gears with various pressure angles. Methods: We calculated the deflection and ...
متن کاملCalculation of the Tooth Root Load Carrying Capacity of Beveloid Gears
Printed with permission of the copyright holder, the American Gear Manufacturers Association, 1001 N. Fairfax Street, Fifth Floor, Alexandria, VA 22314-1587. Statements presented in this paper are those of the author(s) and may not represent the position or opinion of the American Gear Manufacturers Association. In this paper, two developed methods of tooth root load carrying capacity calculati...
متن کاملLoad Carrying Capacity of Simply Supported Variable Thickness Circular Plates
The calculation of the load carrying capacity of variable thickness circular plates subjected to arbitrary rotational symmetric loading is presented. The analysis considers plate materials that obey either the square or the Tresca yield criterion. By using upper and lower bound theorems of limit analysis, corresponding estimations for the load carrying capacity of the plate are obtained. It is ...
متن کاملUltimate Load Capacity and Behavior of Thin-Walled Curved-Steel Square Struts, Subjected to Compressive Load
There have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. One set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. Different lengths of curved struts are fabricated so as to cover a practical ...
متن کاملOptimal Trajectory of Flexible Manipulator with Maximum Load Carrying Capacity
In this paper, a new formulation along with numerical solution for the problem of finding a point-to-point trajectory with maximum load carrying capacities for flexible manipulators is proposed. For rigid manipulators, the major limiting factor in determining the Dynamic Load Carrying Capacity (DLCC) is the joint actuator capacity. The flexibility exhibited by light weight robots or by robots o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2019
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.85.591