Load Bearing Capacity Evaluation of New Lattice Girder by Laboratory Test

Evaluation of Pile Bearing Capacity from Non- Failed Load Test Data

Static pile load test to failure is the ultimate procedure available to examine the capacity and integrity of deep foundations. Being expensive and time consuming, the procedure is often substituted for the application of a load to a certain factor (most often two) times the contemplated design load. In fact, only a proof test is carried out while the ultimate capacity and actual factors of saf...

Load Test and Model Calibration of a Horizontally Curved Steel Box-Girder Bridge

In this paper, full scale load test of a horizontally curved steel box-girder bridge is carried out in order to detect structural defects, which reportedly result in unwanted vibrations in nearby buildings. The bridge is tested under the passage of six heavy vehicles at different speeds, so as to determine its static and dynamic responses. A total number of one hundred and two (102) sensors are...

Comparision of Methods for Determining Bearing Capacity of Piles Using Standard Penetration Test (SPT) Data

In recent years, determining bearing capacity of piles from in-situ testing data as a complement to static and dynamic analysis has been used by geotechnical engineers. In this paper, different approaches for estimating bearing capacity of piles from SPT data are studied and compared. A new method based on N value from SPT is presented. Data averaging, &#10failure zone and plunging failure of p...

Evaluation of the Residual Load-bearing Capacity of Civil Structures Using Fuzzy-logic & Decision Analysis

Comparision of Methods for Determining Bearing Capacity of Piles Using Standard Penetration Test (SPT) Data

In recent years, determining bearing capacity of piles from in-situ testing data as a complement to static and dynamic analysis has been used by geotechnical engineers. In this paper, different approaches for estimating bearing capacity of piles from SPT data are studied and compared. A new method based on N value from SPT is presented. Data averaging, failure zone and plunging failure of pil...