Lithotamnian limestone from the deposit 'Dobrilovici' in flue gas desulphurization by wet process
نویسندگان
چکیده
منابع مشابه
Dynamics of wet flue gas desulphurization in spray absorber
A concise one dimensional thermal-hydraulic two-fluid model is presented for the numerical prediction of sulphur dioxide absorption from the flue gas onto drops of the water-limestone slurry in the vertical spray tower absorber. The model is based on mass, momentum and energy balance equations for each phase separately, i.e. downward falling droplets of water-limestone slurry and upward flowing...
متن کاملInvestigation of Parameters Affecting Gypsum Dewatering Properties in a Wet Flue Gas Desulphurization Pilot Plant
Wet flue gas desulphurization (FGD) plants with forced oxidation, installed at coal and oil fired power plants for removal of SO2(g), must produce gypsum of high quality. However, quality issues such as an excessive moisture content, due to poor gypsum dewatering properties, may occur from time to time. In this work, the particle size distribution, morphology, and filtration rate of wet FGD gyp...
متن کاملInvestigation on Mercury Reemission from Limestone-Gypsum Wet Flue Gas Desulfurization Slurry
Secondary atmospheric pollutions may result from wet flue gas desulfurization (WFGD) systems caused by the reduction of Hg(2+) to Hg(0) and lead to a damping of the cobenefit mercury removal efficiency by WFGD systems. The experiment on Hg(0) reemission from limestone-gypsum WFGD slurry was carried out by changing the operating conditions such as the pH, temperature, Cl(-) concentrations, and o...
متن کاملParameters Affecting Efficiency of Flue Gas Desulfurization System Using Wet Limestone Method
Efficiency of Flue Gas Desulfurization System (FGD) is affected by numerous technical parameters like: proper fuel preparation, quantity and quality of fuel, combustion conditions in furnace chamber, quality of flue gas corresponding to the operating conditions of FGD system, design quantity and quality of flue gas at the inlet of FGD system, design quantity and quality of used sorbent, design ...
متن کاملThe thief process for mercury removal from flue gas.
The Thief Process is a cost-effective variation to activated carbon injection (ACI) for removal of mercury from flue gas. In this scheme, partially combusted coal from the furnace of a pulverized coal power generation plant is extracted by a lance and then re-injected into the ductwork downstream of the air preheater. Recent results on a 500-lb/h pilot-scale combustion facility show similar rem...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Rudarski radovi, Bor
سال: 2012
ISSN: 1451-0162
DOI: 10.5937/rudrad1203041s