Light-Induced Al Plating on Si for Fabrication of an Ag-Free All-Al Solar Cell
نویسندگان
چکیده
منابع مشابه
/Al-Doped Ag Electrode for Resonant Light Harvesting in Effi cient Organic Solar Cells
Moreover, to further boost the device effi ciency, a resonant optical cavity can be created between the transparent thin Ag fi lm and an opaque back contact metal electrode, thus trapping light inside the active layer and enhancing its light absorption. [ 22 ] However, Ag follows 3D growth mode: during deposition, Ag atoms fi rst agglomerate into isolated islands, and as the deposition continue...
متن کاملInfluence of strain in Ag on Al(111) and Al on Ag(100) thin film growth
We demonstrate the influence of interfacial strain on the growth modes of Ag films on Al(111), despite the small magnitude of the lattice misfit in this system. The strain is relieved by the formation of stacking fault domains bounded by Shockley partial dislocations. The growth mode and the step roughness appear to be strongly connected. Growth is three-dimensional (3D) as long as the steps ar...
متن کاملPlasmon-induced broadband fluorescence enhancement on Al-Ag bimetallic substrates
Surface enhanced fluorescence (SEF) utilizes the local electromagnetic environment to enhance fluorescence from the analyte on the surface of a solid substrate with nanostructures. While the detection sensitivity of SEF is improved with the development of nano-techniques, detection of multiple analytes by SEF is still a challenge due to the compromise between the high enhancing efficiency and b...
متن کاملEffect of Deformation-Induced Defects on the Microstructure and Pitting Corrosion Behavior of Al-Ag Alloy
In this study, a wide range of combined ageing treatments and cold work deformations in the Al 4.2 wt% Ag alloy matrix were proposed, aiming to investigate the effect of defects such as precipitates (Ag2Al plates) and dislocations on the mechanical and electrochemical behavior of Al–4.2 wt% Ag alloys. Further reductions of thickness from 10 to 60%, decreases the mean size of Ag2...
متن کاملAn Investigation of the Use of Ni3Al Intermetallic Compound for Fabrication of Al Matrix Composites
Fabrication and characterization of aluminum matrix composites containing different volume fractions of Ni3Al powder (5-40 Vol%) were investigated. Ni3Al powder was produced by mechanical alloying of elemental nickel and aluminum powder mixture. Al-Ni3Al composite parts were prepared using a powder metallurgy route involving two stages Al and Ni3Al powder mixtures were first compacted under 500...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Journal of Solid State Science and Technology
سال: 2021
ISSN: 2162-8769,2162-8777
DOI: 10.1149/2162-8777/abdc00