Less-rigid coating in Ti obtained by laser surface alloying with Nb
نویسندگان
چکیده
منابع مشابه
The effect of alloying on the properties of (Nb,Ti)Cr2 C15 Laves phases
The effect of composition on the ternary (NbCr2–TiCr2) C15 phase properties has been investigated, focusing upon the defect structure, elastic properties, and mechanical behavior. The C15 phase field is continuous between NbCr2–TiCr2, with a maximum phase field width of at least 7 at.% solubility. The defect mechanism is governed by anti-site constitutional defects for all alloys. Mechanically,...
متن کاملFe-doped SnO2 obtained by mechanical alloying
In this work, iron-doped SnO2 powders were prepared by two methods: mechanical alloying and mechanochemical alloying with successive thermal treatment. The influence of different milling conditions such as ball to powder weight ratio, milling time, rotation velocity of supporting disc and the type of iron starting reactive and their Fe concentration on the structural and magnetic properties of ...
متن کاملTIG Surface Alloying of Ti-6Al-4V with Nitrogen and Chromium for Improved Tribological Properties
Due to special properties such as low density, high strength and high corrosion resistance Ti-6Al-4V alloy has been used extensively in various industries, especially in the aerospace aspects. However the major problem of this alloy is its poor tribological properties under relatively high loads. In the present study, in order to improve the tribological properties of mentioned alloy, chromium ...
متن کاملNanocrystalline Hydroxyapatite/Si Coating by Mechanical Alloying Technique
A novel approach for depositing hydroxyapatite (HA) films on titanium substrates by using mechanical alloying (MA) technique has been developed. However, it was shown that one-hour heat treatment at 800°C of such mechanically coated HA layer leads to partial transformation of desired HA phase to beta-tri-calcium phosphate (β-TCP) phase. It appears that the grain boundary and interface defects f...
متن کاملStructure and properties of Al67Ti25Fe8 alloy obtained by mechanical alloying
Purpose: The goal of this work is to investigate structure and properties of powdersAl67Ti25Fe8 alloys obtained by mechanical alloying. Design/methodology/approach: The powders of the Al67Ti25Fe8 alloys were obtained by mechanical alloying method in a planetary Fritsh Pulverisette 5 mill. The changes of the constitution phases were tested by means of the X-ray diffractometer. The microscopic ob...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Surface and Coatings Technology
سال: 2018
ISSN: 0257-8972
DOI: 10.1016/j.surfcoat.2018.04.038