LAYER-TO-LAYER ANGLE INTERLOCK 3D WOVEN BANDSTOP FREQUENCY SELECTIVE SURFACE
نویسندگان
چکیده
منابع مشابه
Tension–tension fatigue behavior of layer-to-layer 3-D angle- interlock woven composites
The tension–tension fatigue behavior of (the layer-to-layer) three-dimensional angle-interlock woven composite (3DAWC) was investigated using the acoustic emission (AE) technique, examination of damaged regions via light microscopy and micro-CT, and finite element analysis (FEA). AE events occurred during the entire fatigue process, and damage modes were determined based on cumulative fatigue d...
متن کاملSingle - Layer Bandpass Active Frequency Selective Surface
If you believe this document infringes copyright then please contact the KAR admin team with the take-down information provided at http://kar.kent.ac.uk/contact.html Citation for published version Ghaffer, I Kiani. and Ford, Kenneth L. and Esselle, Karu P. and Weily, Andrew R. and Panagamuwa, C. and Batchelor, John C. (2008) Single-Layer Bandpass Active Frequency Selective Surface. Microwave an...
متن کاملSingle-Layer Bandpass Active Frequency Selective Surface
A single-layer, bandpass, active FSS is presented. It shows good angle of incidence stability for TE incidence, at the operating frequency of 2.45 GHz. It is based on circular loop aperture with each unit cell having four PIN diodes. A novel method for dc biasing is used. About 12 dB average variation in transmission loss, between ON and OFF states, has been experimentally achieved at 2.45 GHz.
متن کاملA Constant Gain Ultra-wideband Antenna with a Multi-layer Frequency Selective Surface
An ultra-wideband (UWB) antenna with a novel multilayer frequency selective surface (FSS) reflector is presented. A significant enhancement in the gain has been achieved in a low profile design while maintaining the excellent impedance bandwidth of the UWB antenna. The average peak gain of the antenna has been increased from 4 dBi to 9.3 dBi as a consequence of the use of the FSS reflector. Mor...
متن کاملPolarization Independent Triple-Band Single Layer Frequency Selective Structure
This paper deals with single layer polarization independent Frequency selective surface (FSS) which acts as a triple band reject filter. The two stop bands are broad with percentage bandwidth 11.16% and 10.13% and one is narrow with 3.33% bandwidth. The band ratio is more than 1.5 and band separation is around 30-35dB. This design is investigated theoretically by ANSOFT® Designer software and p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Progress In Electromagnetics Research
سال: 2018
ISSN: 1559-8985
DOI: 10.2528/pier18041707