Lattice contraction during amorphization by mechanical alloying
نویسندگان
چکیده
منابع مشابه
Effect of Ni on Amorphization of Ti-Cu-Ni Ternary alloys Prepared by Mechanical alloying
Amorphous alloys has been taken into consideration because of their unique properties and are nominated as the future engineering materials. In this research, the effect of Ni and milling time on amorphization process and thermal stability of Ti50Cu50-xNix(x=10, 15, 25 at%) alloy system were investigated. The evolution of amorphization during milling, thermal stability and subsequent heat treat...
متن کاملRaney-nickel Catalysts Produced by Mechanical Alloying
Raney catalysts were prepared by a combination of mechanical alloying and leaching as an alternative in the synthesis of Raney-Nickel catalysts. Binary Al-Ni and ternary Al-Ni-Fe alloys with nominal compositions Al65Ni35, Al75Ni25, Al65Ni30Fe5, Al75Ni20Fe5 (in atomic percent), were processed from pure elemental powders; they consisted mainly of the intermetallic B2 AlNi phase. Aluminum was sele...
متن کاملFe-doped SnO2 obtained by mechanical alloying
In this work, iron-doped SnO2 powders were prepared by two methods: mechanical alloying and mechanochemical alloying with successive thermal treatment. The influence of different milling conditions such as ball to powder weight ratio, milling time, rotation velocity of supporting disc and the type of iron starting reactive and their Fe concentration on the structural and magnetic properties of ...
متن کاملDiaphragmatic contraction during assisted mechanical ventilation.
Indirect evidence from airway pressure recordings in mechanically ventilated patients suggests that the diaphragm exhibits contractile activity beyond that required to trigger a ventilator-assisted breath. We used the diaphragmatic EMG to provide direct evidence of persistent contractile activity and studied the effects of alterations in ventilator-delivered flow rate and tidal volume on the du...
متن کاملInvestigation on Mechanical and Electrical Properties of Cu-Ti Nanocomposite Produced by Mechanical Alloying
In this paper, Cu-Ti nanocomposite synthesized via ball milling of copper-titanium powders in 1, 3, and 6 of weight percentage compounds. The vial speed was 350 rpm and ball to powder weight ratio kept at 15:1 under Argon atmosphere, and the time of milling was 90 h. Obtained powders were studied by scanning electron microscopy (SEM), X-ray diffraction (XRD), and dynamic light scattering (DLS)....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Physics
سال: 2008
ISSN: 0021-8979,1089-7550
DOI: 10.1063/1.3020531