Lateral torsional buckling of doubly symmetric I-shaped steel members under linear moment gradient

The effect of discrete lateral and torsional bracings stiffness on the elastic lateral-torsional buckling of mono-symmetric I beam, under the concentrated moment

When the out-of-plane stiffness of a beam is remarkably lower than the in-plane stiffness, the lateral-torsional buckling occurs. In this study, the behavior of mono-symmetric I-beams with discrete torsional and lateral bracings under the concentrated moment is investigated using the finite element analyses. Then, based on the numerical analyses, equation for the stiffness requirement is propos...

Lateral Torsional Buckling of Steel Thin-Walled Beams with Lateral Restraints

Metal thin-walled members have been widely used in building industry. Usually they are utilized as purlins, girts or ceiling beams. Due to slenderness of thin-walled cross-sections these structural members are prone to stability problems (e.g. flexural buckling, lateral torsional buckling). If buckling is not constructionally prevented their resistance is limited by buckling strength. In practi...

Lateral-torsional buckling resistance of cold-formed high strength steel rectangular hollow beams

Hollow sections have been widely used for steel structures. Applications of High Strength Steel (HSS) on cold-formed hollow sections lead to thinner and lighter structures. This paper presents numerical investigations on the lateral-torsional buckling resistance of the cold-formed high strength steel rectangular hollow beam. Results from finite element analysis using Abaqus software are compare...

Advanced Analysis of Steel Frame Structures Subjected to Lateral Torsional Buckling Effects

Local and Distortional Buckling of Cold-Formed Steel Members

Laminar structures have a high post-buckling strength reserve. Cold-formed steel profiles can be taken as a set of thin plate elements. Therefore it is necessary to design this type of profiles taking into account that reserve of strength in post-local buckling modes of failure. The method normally used to design this type of structures is based on the Effective Width concept. The Effective Wid...