منابع مشابه
Heat accumulation during pulsed laser materials processing.
Laser materials processing with ultra-short pulses allows very precise and high quality results with a minimum extent of the thermally affected zone. However, with increasing average laser power and repetition rates the so-called heat accumulation effect becomes a considerable issue. The following discussion presents a comprehensive analytical treatment of multi-pulse processing and reveals the...
متن کاملRecent Development in Laser Materials Processing
Recent research and development in laser machining and laser forming processes is reviewed. In the laser machining area, striation formation and prediction, and gas jet workpiece interactions are discussed. In the laser forming area, strain rate effects, and convex forming are presented.
متن کاملUltrafast parallel laser processing of materials for high throughput manufacturing
Laser patterning is a key industrial process in the manufacturing of organic light emitting diode (OLED) displays, solid-state lighting foils and solar cells. Ultrafast lasers are of particular interest for this application as they may enable selective ablative removal of OLED layers with minimal energy density requirements on the target. Since sufficient laser output from commercial laser sour...
متن کاملOn-line Optodynamic Monitoring of Laser Materials Processing
A new term “optodynamics” has been introduced to describe a wide range of optically induced dynamic phenomena (Možina & Hrovatin, 1996). A laser pulse is considered not only as a tool in laser material processing but also as a generator of information about the material transformation. The information is retained and conveyed by different kinds of optically induced mechanical waves generated du...
متن کاملMaterials processing with a tightly focused femtosecond laser vortex pulse.
In this Letter we present the first (to our knowledge) demonstration of material modification using tightly focused single femtosecond laser vortex pulses. Double-charge femtosecond vortices were synthesized with a polarization-singularity beam converter based on light propagation in a uniaxial anisotropic medium and then focused using moderate- and high-NA optics (viz., NA=0.45 and 0.9) to abl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Laser Technik Journal
سال: 2013
ISSN: 1613-7728
DOI: 10.1002/latj.201390001