Laser Material Processing for Aerospace Applications
نویسندگان
چکیده
منابع مشابه
Adaptive Optics Control for Laser Material Processing
An adaptive optics system is used for correcting tip-tilt disturbances in an experimental laser material processing setup. The proposed tip-tilt controller is based on PI-controllers that are fed with disturbance estimates from a Kalmanfilter. In addition, delays due to wavefront computation in the wavefront sensor and from data transmission are taken into account in the loop-shaping design. La...
متن کاملTubular filamentation for laser material processing
An open challenge in the important field of femtosecond laser material processing is the controlled internal structuring of dielectric materials. Although the availability of high energy high repetition rate femtosecond lasers has led to many advances in this field, writing structures within transparent dielectrics at intensities exceeding 10(13) W/cm(2) has remained difficult as it is associat...
متن کاملNew Processing of Composite Grids for Aerospace Applications
Composite materials exhibit their highest stiffness and strength in unidirectional format. Any deviation from this lead to lower fiber volume fractions, and lower properties. Composites grids can be exceptionally stiff and strong if their ribs are umdircct.üii|ü. Several approaches have been published in recent years. Modeling of mull.c„cct.onal grids is simple because it follows the assumption...
متن کاملA Motion Control Strategy for Robots in Laser Material Processing and other High Speed Applications
Laser-robots are well-established in the material processing industry. They are used for cutting, welding and marking of work pieces made from diverse materials. In these applications it is important to move the focal spot of the laser beam exactly along the desired machining contour on the work piece. Available laser sources are powerful enough to allow for very high machining velocities, whic...
متن کاملNonminimum Phase Behavior of Laser Material Processing
Optical sensors are increasingly applied in laser material processing to monitor and control the lasermaterial interaction zone. Dynamic models, relating the sensor signals (e.g. as temperature or molten area) to the process inputs (e.g. laser power or beam velocity), provide the basis for the design and tuning of a feedback controller. These models can show nonminimum phase (NMP) behavior. Thi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Aeronautics & Aerospace Engineering
سال: 2012
ISSN: 2168-9792
DOI: 10.4172/2168-9792.1000e120